Wildcatbutte soil
Wild-clay potential
Weak indication
Weak indication: no layer of Wildcatbutte shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Wildcatbutte soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Wildcatbutte spot on the map
Rated from the USDA soil survey record for Wildcatbutte-Chesebro-Glassbutte complex, 20 to 65 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 8% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 36 in (91 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 70% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA A gravelly ashy fine sandy loam layer about 0 to 4 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBw A very cobbly ashy loam layer about 4 to 24 in down: about 14% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBkqbest layer An extremely cobbly ashy sandy loam layer about 24 to 60 in down: about 8% clay, low plasticity when wet, brown when moist. Weak indication
What it looks like raw
The sandy layer (Bkq), 24 to 60 in down in the typical profile: brown (10YR 5/3), dark brown (10YR 3/3) moist; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash and colluvium and residuum derived from volcanic rock such as welded tuff or basalt.
- USDA family particle-size class: ashy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon. These soils are not extensive with about 3,900 acres of the series mapped to date. MLRA 23.
USDA, geographic setting: Wildcatbutte soils are on lava plateaus, hills, or mountains. They typically occur on backslope positions. These soils formed in volcanic ash and colluvium over residuum derived from basalt or welded tuff. Slopes are 15 to 65 percent. Elevations range from 1,220 to 1,770 meters feet. The climate is semiarid with cool, moist winters and warm, dry summers. The mean annual precipitation is 200 to 330 mm, the mean annual temperature is 6 to 7 degrees C, and the frost-free period is 50 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
See it on the map
Open a Wildcatbutte spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 35%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Wildcatbutte-Chesebro-Glassbutte complex, 20 to 65 percent slopes, map unit 675 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Wildcatbutte(revised 06/2011), established.
- Taxonomic class: Ashy-skeletal, glassy, frigid Vitritorrandic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.