Hayespring soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 17 to 24 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Hayespring soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Hayespring spot on the map
Rated from the USDA soil survey record for Hayespring-Moonbeam complex, 2 to 20 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 36% clay in the fine-earth portion.
- Note USDA labels this a "Bt2" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (25): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 7 in (18 cm)).
- Note Typically starts within about 17 in (43 cm) of the surface.
- Note Few rock fragments (about 7% by volume).
Layer by layer
- TopsoilA1 A gravelly ashy loam layer about 0 to 3 in down: about 20% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- TopsoilA2 A stony ashy fine sandy loam layer about 3 to 10 in down: about 17% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBt1 A cobbly ashy clay loam layer about 10 to 17 in down: about 32% clay, high plasticity when wet, brown when moist. Possible
- Clay subsoilBt2best layer An ashy clay loam layer about 17 to 24 in down: about 36% clay, high plasticity when wet, light brown when moist. Strong lead
- Bqm A cemented material layer about 24 to 44 in down: USDA gives no clay percentage or texture for it. Not enough data
- BedrockR Bedrock about 44 to 54 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt2), 17 to 24 in down in the typical profile: light brown (7.5YR 6/3), brown (7.5YR 4/4) moist; hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed volcanic ash and residuum derived from volcanic rock such as basalt.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 44 in (112 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon. These soils are moderately extensive. MLRA 23.
USDA, geographic setting: Hayespring soils are on lava plateaus. These soils formed in volcanic ash over residuum derived from basalt. Slopes are 0 to 20 percent. Elevations range from 1,345 to 1,640 meters. The climate is semiarid and characterized by cold, moist winters and warm, dry summers. The mean annual precipitation is typically 250 to 300 mm but may range as low as 230 mm and as high as 330 mm, the mean annual temperature is 6 to 7 degrees C, and the frost-free period is 60 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
- Brabble: Promising
See it on the map
Open a Hayespring spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Hayespring-Moonbeam complex, 2 to 20 percent slopes, map unit 354 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Hayespring(revised 03/2011), established.
- Taxonomic class: Fine-loamy, isotic, frigid Vitritorrandic Durixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.