Connleyhills soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 22 to 29 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Connleyhills soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Connleyhills spot on the map
Rated from the USDA soil survey record for Connleyhills cobbly ashy loam, 2 to 20 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 46% clay in the fine-earth portion.
- Note USDA labels this a "2Bt3" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (30): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and very plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 7 in (18 cm)).
- Note Typically starts within about 22 in (56 cm) of the surface.
- Note Few rock fragments (about 10% by volume).
- Note High shrink-swell (linear extensibility about 6.9%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA1 A cobbly ashy loam layer about 0 to 4 in down: about 20% clay, low plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA2 An ashy coarse sandy loam layer about 4 to 11 in down: about 9% clay, low plasticity when wet, brown when moist. Weak indication
- Clay subsoil2Bt1 A very cobbly ashy clay loam layer about 11 to 15 in down: about 32% clay, high plasticity when wet, brown when moist. Weak indication
- Clay subsoil2Bt2 A very cobbly clay layer about 15 to 22 in down: about 42% clay, high plasticity when wet, yellowish brown when moist. Possible
- Clay subsoil2Bt3best layer A clay layer about 22 to 29 in down: about 46% clay, high plasticity when wet, pale brown when moist. Strong lead
- Clay subsoil3Bt4 A very stony ashy clay loam layer about 29 to 32 in down: about 36% clay, high plasticity when wet, brown when moist. Weak indication
- Bedrock3R Bedrock about 32 to 42 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (2Bt3), 22 to 29 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; very hard, very friable, moderately sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash over residuum derived from volcanic rock such as basalt or tuff-breccia.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: clayey-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 32 in (81 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon. These soils are not extensive with about 8,400 acres of the series mapped to date. MLRA 23.
USDA, geographic setting: Connleyhills soils are on lava plateaus. These soils formed in volcanic ash over residuum derived from basalt. Slopes are 1 to 20 percent. Elevations range from 1,325 to 1,590 meters. The climate is semiarid and characterized by cool, moist winters and warm, dry summers. The mean annual precipitation is typically 200 to 300 mm but may range to 400 mm in some areas. The mean annual air temperature is 6 to 7 degrees C. The frost-free period is 50 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
- Brabble: Promising
See it on the map
Open a Connleyhills spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Connleyhills cobbly ashy loam, 2 to 20 percent slopes, map unit 255 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Connleyhills(revised 01/2011), established.
- Taxonomic class: Clayey-skeletal, smectitic, frigid Vitritorrandic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.