Moonbeam soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 8 to 14 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Moonbeam soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Moonbeam spot on the map
Rated from the USDA soil survey record for Moonbeam-Goodtack complex, 1 to 10 percent slopes (Harney County Area, Oregon) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Note USDA labels this a "2Bt1" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (35): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and very plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 6 in (16 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
- Note High shrink-swell (linear extensibility about 8%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA1 An ashy very fine sandy loam layer about 0 to 3 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA2 A gravelly ashy sandy clay loam layer about 3 to 8 in down: about 20% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Clay subsoil2Bt1best layer A clay layer about 8 to 14 in down: about 48% clay, high plasticity when wet, light brown when moist. Strong lead
- Clay subsoil2Bt2 A clay layer about 14 to 18 in down: about 44% clay, high plasticity when wet, light brown when moist. Promising
- 2Bqm A cemented material layer about 18 to 27 in down: USDA gives no clay percentage or texture for it. Not enough data
- Bedrock2R Bedrock about 27 to 37 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (2Bt1), 8 to 14 in down in the typical profile: light brown (7.5YR 6/3), brown (7.5YR 4/3) moist; very hard, friable; moderately sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: Volcanic ash over residuum derived from volcanic rock such as basalt.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: clayey.
- Drainage: well drained.
- Lithic bedrock typically about 27 in (69 cm) down.
Where it is mapped
Seen on the map as the most common soil in 6 map units in Oregon, in these survey areas: Harney County Area, Oregon; Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties; Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon. These soils are extensive with about 123,000 acres of the series mapped to date. MLRA 23.
USDA, geographic setting: Moonbeam soils are on lava plateaus. They typically occur on summit positions. These soils formed in volcanic ash over residuum derived from basalt. Slopes are 0 to 20 percent. Elevations range from 1,250 to 1,830 meters. The climate is semiarid and characterized by cold, moist winters and warm, dry summers. The mean annual precipitation is 230 to 300 mm, but ranges to 400 mm in some areas. The mean annual temperature is 6 to 7 degrees C, and the frost-free period is 50 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Swalesilver: Strong lead
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Ninemile: Promising
See it on the map
Open a Moonbeam spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 45%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Moonbeam-Goodtack complex, 1 to 10 percent slopes, map unit 374 in Harney County Area, Oregon.
- Official Series Description: Moonbeam(revised 04/2011), established.
- Taxonomic class: Clayey, smectitic, frigid, shallow Vitritorrandic Durixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.