Chancelakes soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 29 to 58 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Chancelakes soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Chancelakes spot on the map
Rated from the USDA soil survey record for Chancelakes-Silverash complex, 0 to 1 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 41% clay in the fine-earth portion.
- Note USDA labels this a "Btkss" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (30): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 29 in (73 cm)).
- Note Typically starts about 29 in (74 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 6.4%): often very plastic, and prone to cracking as it dries.
Layer by layer
- TopsoilAE An ashy silt loam layer about 0 to 1 in down: about 12% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBt A clay layer about 1 to 10 in down: about 44% clay, high plasticity when wet, dark grayish brown when moist. Strong lead
- Clay subsoilBtk A clay layer about 10 to 29 in down: about 47% clay, high plasticity when wet, dark grayish brown when moist. Strong lead
- Clay subsoilBtkssbest layer A clay layer about 29 to 58 in down: about 41% clay, high plasticity when wet, dark grayish brown when moist. Strong lead
- Loamy layerB'tk An ashy sandy clay loam layer about 58 to 63 in down: about 30% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
What it looks like raw
The clay subsoil (Btkss), 29 to 58 in down in the typical profile: dark grayish brown (2.5Y 4/2), light brownish gray (2.5Y 6/2) dry; hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: lacustrine deposits derived from volcanic rock such as basalt and tuff with an influence of volcanic ash.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon. These soils are not extensive with about 1,850 acres of the series mapped to date. MLRA 23.
USDA, geographic setting: Chancelakes soils are on depressions and drainageways on plateaus. These soils formed in lacustrine deposits derived from volcanic rocks such as basalt and tuff with an influence of volcanic ash. Slopes are 0 to 2 percent. Elevations range from 1,325 to 1,550 meters. The climate is semiarid with cold, moist winters and warm, dry summers. The mean annual precipitation is 250 to 300 mm, the mean annual temperature is 6 to 7 degrees C., and the frost-free period is 50 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
- Brabble: Promising
See it on the map
Open a Chancelakes spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 70%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Chancelakes-Silverash complex, 0 to 1 percent slopes, map unit 246 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Chancelakes(revised 01/2011), established.
- Taxonomic class: Fine, smectitic, frigid Xeric Epiaquerts
- Rated with rule version 2026-09-28.1; the method is on the About page.