Tonor soil
Wild-clay potential
Weak indication
Weak indication: no layer of Tonor shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tonor soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Tonor ashy silt loam, 0 to 1 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Note Moderate engineering plasticity index (10).
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 32 in (81 cm)).
- Note Typically starts within about 11 in (28 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 10% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA An ashy silt loam layer about 0 to 3 in down: about 15% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerBw An ashy loam layer about 3 to 11 in down: about 15% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Sandy layerBknbest layer An ashy sandy loam layer about 11 to 43 in down: about 15% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Loamy layer2C A very paragravelly ashy silt loam layer about 43 to 60 in down: about 20% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The sandy layer (Bkn), 11 to 43 in down in the typical profile: pale brown (10YR 6/3), dark grayish brown (10YR 4/2) moist; slightly hard, friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: lacustrine deposits derived from volcanic ash.
- USDA family particle-size class: ashy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon. These soils are moderately extensive. MLRA 23.
USDA, geographic setting: Tonor soils are on lakebeds. These soils formed in lacustrine deposits derived from volcanic ash. The source of the volcanic ash is ancestral Mt. Mazama. Slopes are 0 to 15 percent. Elevations range from 1,300 to 1,400 meters. The climate is semiarid with cool, moist winters and warm, dry summers. The mean annual precipitation is 200 to 250 mm, the mean annual temperature is 6 to 7 degrees C, and the frost-free period is 50 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tonor ashy silt loam, 0 to 1 percent slopes, map unit 638 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Tonor(revised 06/2011), established.
- Taxonomic class: Ashy, glassy, frigid Sodic Xeric Haplocambids
- Rated with rule version 2026-09-28.1; the method is on the About page.