Suckerflat soil
Wild-clay potential
Weak indication
Weak indication: no layer of Suckerflat shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Suckerflat soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Suckerflat spot on the map
Rated from the USDA soil survey record for Suckerflat ashy loamy sand, 0 to 8 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 17% clay.
- Note Moderate engineering plasticity index (10).
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Moderate thickness (about 10 in (26 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 18% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilA An ashy loamy sand layer about 0 to 8 in down: about 5% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBwbest layer A cobbly ashy loam layer about 8 to 18 in down: about 17% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Bedrock2R Bedrock about 18 to 28 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (Bw), 8 to 18 in down in the typical profile: grayish brown (10YR 5/2), dark brown (10YR 3/3) moist; slightly hard, friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash and slope alluvium or colluvium derived from volcanic rock such as basalt or tuff-breccia.
- USDA family particle-size class: ashy.
- Drainage: well drained.
- Lithic bedrock typically about 18 in (46 cm) down.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon. These soils are moderately extensive. MLRA 23.
USDA, geographic setting: Suckerflat soils are on lava plains, lava plateaus and hills. These soils formed in volcanic ash over slope alluvium and colluvium derived mainly from basalt and tuff-breccia. Slopes are 0 to 40 percent. Elevations range from 1,310 to 1,610 meters. The climate is semiarid and characterized by cold, moist winters and warm, dry summers. The mean annual precipitation is 200 to 300 mm, the mean annual temperature is 6 to 7 degrees C,and the frost-free period is 40 to 70 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
See it on the map
Open a Suckerflat spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Suckerflat ashy loamy sand, 0 to 8 percent slopes, map unit 613 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Suckerflat(revised 07/2011), established.
- Taxonomic class: Ashy, glassy, frigid Aridic Lithic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.