Salhouse soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 42 to 61 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Salhouse soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Salhouse spot on the map
Rated from the USDA soil survey record for Salhouse ashy loamy fine sand, 3 to 15 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 25% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 19 in (48 cm)).
- Note Typically starts about 42 in (107 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- TopsoilA An ashy loamy fine sand layer about 0 to 5 in down: about 5% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerC An ashy loamy sand layer about 5 to 42 in down: about 3% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerBwbbest layer An ashy silt loam layer about 42 to 61 in down: about 25% clay, moderate plasticity when wet, light brownish gray when moist. Possible
What it looks like raw
The loamy layer (Bwb), 42 to 61 in down in the typical profile: light brownish gray (10YR 6/2), dark grayish brown (10YR 4/2) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: eolian deposits derived from volcanic ash over lacustrine deposits derived from volcanic ash and mixed volcanic rock.
- USDA family particle-size class: ashy.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon. These soils are moderately extensive. MLRA 23.
USDA, geographic setting: Salhouse soils are on stable dunes on beach ridges and sand sheets on lakebeds. These soils formed in eolian material derived from volcanic ash over lacustrine deposits derived from volcanic rocks. Slopes are 0 to 20 percent. Elevations range from 1,280 to 1,375 meters. The climate is semiarid and characterized by cold, moist winters and warm, dry summers. The mean annual precipitation is 200 to 250 mm, the mean annual temperature is 6 to 7 degrees C, and the frost-free period is 50 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
See it on the map
Open a Salhouse spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Salhouse ashy loamy fine sand, 3 to 15 percent slopes, map unit 571 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Salhouse(revised 06/2011), established.
- Taxonomic class: Ashy, glassy, calcareous, frigid Vitrandic Torripsamments
- Rated with rule version 2026-09-28.1; the method is on the About page.