Oatmanflat soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 28 to 44 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Oatmanflat soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Oatmanflat spot on the map
Rated from the USDA soil survey record for Oatmanflat ashy very fine sandy loam, 0 to 2 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 25% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Btb" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (15).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 16 in (41 cm)).
- Note Typically starts about 28 in (71 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- TopsoilA1 An ashy very fine sandy loam layer about 0 to 3 in down: about 18% clay, low plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA2 An ashy sandy clay loam layer about 3 to 12 in down: about 20% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerBw An ashy coarse sandy loam layer about 12 to 28 in down: about 20% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Clay subsoilBtbbest layer An ashy clay loam layer about 28 to 44 in down: about 25% clay, moderate plasticity when wet, brown when moist. Possible
- Clay subsoilBtqb A gravelly ashy sandy clay loam layer about 44 to 53 in down: about 25% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
- Bkqmb A cemented material layer about 53 to 64 in down: USDA gives no clay percentage or texture for it. Not enough data
What it looks like raw
The clay subsoil (Btb), 28 to 44 in down in the typical profile: brown (10YR 5/3), brown (10YR 4/3) moist; slightly hard, friable, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash and alluvium derived from volcanic rock such as basalt.
- USDA family particle-size class: ashy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon. These soils are not extensive with about 3,900 acres of the series mapped to date. MLRA 23.
USDA, geographic setting: Oatmanflat soils are on low stream terraces and in swales on lava plateaus. These soils formed in alluvium derived from volcanic ash and basalt. Slopes are 0 to 5 percent. Elevations range from 1,345 to 1,555 meters. The climate is semiarid and characterized by cool, moist winters and warm, dry summers. The mean annual precipitation is 200 to 300 mm, the mean annual temperature is 6 to 7 degrees C, and the frost-free period is 40 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
See it on the map
Open a Oatmanflat spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Oatmanflat ashy very fine sandy loam, 0 to 2 percent slopes, map unit 493 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Oatmanflat(revised 10/2011), established.
- Taxonomic class: Ashy, glassy, frigid Vitritorrandic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.