Lonegrave soil
Wild-clay potential
Weak indication
Weak indication: no layer of Lonegrave shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lonegrave soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Lonegrave spot on the map
Rated from the USDA soil survey record for Lonegrave-Fitzwater-Rock outcrop complex, 20 to 60 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 18% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil moderately sticky and slightly plastic.
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts within about 14 in (36 cm) of the surface.
- Lowers the potential High rock content (about 65% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA A very cobbly loam layer about 0 to 4 in down: about 23% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerBw A very cobbly loam layer about 4 to 14 in down: about 26% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Loamy layerBkbest layer An extremely stony sandy loam layer about 14 to 27 in down: about 18% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- BedrockR Bedrock about 27 to 37 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (Bk), 14 to 27 in down in the typical profile: yellowish brown (10YR 5/4), dark brown (10YR 3/3) moist; slightly hard, firm, moderately sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from volcanic rock such as welded tuff or basalt.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 27 in (69 cm) down.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: Southeastern Oregon. These soils are extensive with about 140,000 acres of the series mapped to date. MLRA 23.
USDA, geographic setting: Lonegrave soils are on plateaus, hills, canyonlands and mountains. They typically occur on shoulder, backslope, and footslope positions. These soils formed in colluvium derived from volcanic rock such as welded tuff or basalt. Slopes are 5 to 70 percent. Elevations range from 1,250 to 2,170 meters. The climate is semiarid and characterized by cool, moist winters and warm, dry summers. The mean annual precipitation is 200 to 360 mm, the mean annual temperature is 7 to 9 degrees C, and the frost-free period is 50 to 100 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
See it on the map
Open a Lonegrave spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 40%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lonegrave-Fitzwater-Rock outcrop complex, 20 to 60 percent slopes, map unit 301 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Lonegrave(revised 11/2022), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, mesic Xeric Haplocambids
- Rated with rule version 2026-09-28.1; the method is on the About page.