Jacksplace soil
Wild-clay potential
Weak indication
Weak indication: no layer of Jacksplace shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Jacksplace soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Jacksplace spot on the map
Rated from the USDA soil survey record for Jacksplace ashy fine sandy loam, moist, 2 to 15 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt2" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 8 in (21 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Lowers the potential High rock content (about 65% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA1 An ashy fine sandy loam layer about 0 to 4 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- TopsoilA2 A cobbly ashy sandy loam layer about 4 to 9 in down: about 11% clay, low plasticity when wet, brown when moist. Weak indication
- Clay subsoilBt1 A very stony ashy sandy loam layer about 9 to 12 in down: about 16% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBt2best layer An extremely stony ashy sandy clay loam layer about 12 to 20 in down: about 23% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Loamy layerC An extremely stony ashy sandy loam layer about 20 to 26 in down: about 18% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- BedrockR Bedrock about 26 to 30 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt2), 12 to 20 in down in the typical profile: yellowish brown (10YR 5/4), dark yellowish brown (10YR 3/4) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash and residuum derived from volcanic rock such as basalt.
- USDA family particle-size class: ashy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 26 in (66 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon. These soils are moderately extensive. MLRA 23.
USDA, geographic setting: Jacksplace soils are on lava plateaus and summits of hills. These soils formed in volcanic ash and residuum derived from basalt. Slopes are 1 to 20 percent. Elevation ranges from 1,310 to 1,830 meters. The climate is semiarid with cold, moist winters and warm, dry summers. The mean annual precipitation is 200 to 360 mm. The mean annual temperature is 6 to 7 degrees C The frost-free period is 50 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
See it on the map
Open a Jacksplace spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Jacksplace ashy fine sandy loam, moist, 2 to 15 percent slopes, map unit 374 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Jacksplace(revised 03/2011), established.
- Taxonomic class: Ashy-skeletal, glassy, frigid Vitritorrandic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.