Gradon soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 10 to 22 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Gradon soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Gradon gravelly fine sandy loam, 0 to 8 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 12 in (31 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- TopsoilA1 A gravelly fine sandy loam layer about 0 to 3 in down: about 15% clay, moderate plasticity when wet, brown when moist. Weak indication
- TopsoilA2 A loam layer about 3 to 10 in down: about 20% clay, moderate plasticity when wet, brown when moist. Possible
- Clay subsoilBtbest layer A clay loam layer about 10 to 22 in down: about 30% clay, high plasticity when wet, light yellowish brown when moist. Promising
- Clay subsoilBtq A gravelly sandy loam layer about 22 to 32 in down: about 16% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
- Bkqm1 A cemented material layer about 32 to 48 in down: USDA gives no clay percentage or texture for it. Not enough data
- Bkqm2 A cemented material layer about 48 to 55 in down: USDA gives no clay percentage or texture for it. Not enough data
- Sandy layerC A sandy loam layer about 55 to 62 in down: about 10% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 10 to 22 in down in the typical profile: light yellowish brown (10YR 6/4), dark yellowish brown (10YR 3/4) moist; hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from mixed volcanic rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Oregon, in these survey areas: Harney County Area, Oregon; Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon. These soils are not extensive. MLRA 23.
USDA, geographic setting: Gradon soils are on fan remnants. These soils formed in alluvium derived from volcanic rocks. Slopes are 0 to 8 percent. Elevations range from 1,310 to 1,615 meters. The climate is semiarid and characterized by cold, moist winters and warm, dry summers. The mean annual precipitation is 250 to 330 mm, the mean annual temperature is 6 to 7 degrees C and the frost-free period is 50 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Moonbeam: Strong lead
- Swalesilver: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Gradon gravelly fine sandy loam, 0 to 8 percent slopes, map unit 344 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Gradon(revised 03/2011), established.
- Taxonomic class: Fine-loamy, mixed, superactive, frigid Argiduridic Durixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.