Glencabin soil
Wild-clay potential
Weak indication
Weak indication: no layer of Glencabin shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Glencabin soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Glencabin spot on the map
Rated from the USDA soil survey record for Glencabin-Rock outcrop complex, moist, 15 to 40 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 14 in (36 cm)).
- Note Typically starts within about 11 in (28 cm) of the surface.
- Lowers the potential High rock content (about 70% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note Surface layer; expect roots and organic matter.
Layer by layer
- TopsoilA1 A gravelly ashy sandy loam layer about 0 to 5 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- TopsoilA2 A cobbly ashy sandy loam layer about 5 to 11 in down: about 15% clay, moderate plasticity when wet, brown when moist. Weak indication
- Topsoil2A3best layer An extremely cobbly ashy loam layer about 11 to 25 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Bedrock2R Bedrock about 25 to 35 in down: no clay layer to dig. Weak indication
What it looks like raw
The topsoil (2A3), 11 to 25 in down in the typical profile: brown (10YR 4/3), dark brown (10YR 3/3) moist; slightly hard, friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash and colluvium and residuum derived from volcanic rock such as rhyolite, basalt, or tuff.
- USDA family particle-size class: ashy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 25 in (64 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon. These soils are moderately extensive. MLRA 23.
USDA, geographic setting: Glencabin soils are on buttes and hills. They typically occur on backslope positions. These soils formed in mixed volcanic ash and colluvium and residuum derived from volcanic rocks. Slopes are 15 to 65 percent. Elevations range from 1,320 to 1,835 meters. The climate is semiarid and characterized by cold, moist winters and warm, dry summers. The mean annual precipitation is 300 to 460 mm, the mean annual temperature is 6 to 7 degrees C, and the frost-free period is 40 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
See it on the map
Open a Glencabin spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 65%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Glencabin-Rock outcrop complex, moist, 15 to 40 percent slopes, map unit 334 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Glencabin(revised 03/2011), established.
- Taxonomic class: Ashy-skeletal, glassy, frigid Vitrandic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.