Fossilake soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 43 to 66 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Fossilake soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Fossilake spot on the map
Rated from the USDA soil survey record for Fossilake ashy fine sandy loam, 0 to 1 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 24% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 23 in (59 cm)).
- Note Typically starts about 43 in (109 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- TopsoilAnz1 An ashy fine sandy loam layer about 0 to 1 in down: about 10% clay, low plasticity when wet, light gray when moist. Weak indication
- TopsoilAnz2 An ashy very fine sandy loam layer about 1 to 3 in down: about 12% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerBn An ashy silt loam layer about 3 to 15 in down: about 24% clay, moderate plasticity when wet, light gray when moist. Possible
- Sandy layerCn A stratified ashy loamy sand to ashy loam layer about 15 to 31 in down: about 10% clay, low plasticity when wet, light gray when moist. Weak indication
- Loamy layerBknb An ashy loam layer about 31 to 43 in down: about 24% clay, moderate plasticity when wet, pale yellow when moist. Possible
- Loamy layerBCgbbest layer An ashy silt loam layer about 43 to 66 in down: about 24% clay, moderate plasticity when wet, white when moist. Possible
What it looks like raw
The loamy layer (BCgb), 43 to 66 in down in the typical profile: white (5Y 8/1), pale olive (5Y 6/4) moist; soft, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: eolian deposits and lacustrine deposits derived from mixed volcanic rock and volcanic ash.
- USDA family particle-size class: ashy.
- Drainage: somewhat poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon. These soils are not extensive with about 1,100 acres of the series mapped to date. MLRA 23.
USDA, geographic setting: Fossilake soils are on depressions on lakebeds. These soils formed in eolian material and lacustrine deposits derived from volcanic rocks and volcanic ash. Slopes are 0 to 1 percent. Elevations range from 1,306 to 1,326 meters. The climate is semiarid and characterized by cold, moist winters and warm, dry summers. The mean annual precipitation is 200 to 250 mm, the mean annual temperature is 6 to 7 degrees C, and the frost-free period is 50 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
See it on the map
Open a Fossilake spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Fossilake ashy fine sandy loam, 0 to 1 percent slopes, map unit 326 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Fossilake(revised 03/2011), established.
- Taxonomic class: Ashy, glassy, calcareous, frigid Aquandic Halaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.