Fort Rock soil
Wild-clay potential
Weak indication
Weak indication: no layer of Fort Rock shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Fort Rock soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Fort Rock spot on the map
Rated from the USDA soil survey record for Fort Rock ashy sandy loam, 0 to 2 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 21 in (53 cm)).
- Note Typically starts about 39 in (99 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- TopsoilA An ashy sandy loam layer about 0 to 5 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBA A gravelly ashy sandy loam layer about 5 to 16 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBw1 An ashy loamy sand layer about 16 to 28 in down: about 8% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layer2Bw2 A very gravelly loamy sand layer about 28 to 35 in down: about 6% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layer2Bq A very gravelly sandy loam layer about 35 to 39 in down: about 7% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layer3Cbest layer An extremely gravelly sand layer about 39 to 60 in down: about 3% clay, low plasticity when wet, very dark gray when moist. Weak indication
What it looks like raw
The sandy layer (3C), 39 to 60 in down in the typical profile: very dark gray (N 3/0), and light yellowish brown (2.5Y 6/4), brown (10YR 4/3), and very dark brown (10YR 2/2) moist; loose, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: Volcanic ash over lacustrine deposits derived from mixed volcanic rock such as basalt or tuff.
- USDA family mineralogy: mixed.
- USDA family particle-size class: ashy over sandy or sandy-skeletal.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon. These soils are moderately extensive. MLRA 23.
USDA, geographic setting: Fort Rock soils are on lake terraces. These soils formed in volcanic ash over lacustrine deposits derived from basalt and tuff. Most of the pumiceous volcanic ash is from ancestral Mt. Mazama (current site of Crater Lake). Slopes are 0 to 8 percent. Elevations range from 1,310 1,480 meters. The climate is semiarid and characterized by cold, moist winters and warm, dry summers. The mean annual precipitation is 200 to 300 mm, mean annual temperature is 6 to 7 degrees C, and the frost-free period is 50 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
See it on the map
Open a Fort Rock spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Fort Rock ashy sandy loam, 0 to 2 percent slopes, map unit 317 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Fort Rock(revised 03/2011), established.
- Taxonomic class: Ashy over sandy or sandy-skeletal, glassy over mixed, frigid Vitritorrandic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.