Fitzwater soil
Wild-clay potential
Weak indication
Weak indication: no layer of Fitzwater shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Fitzwater soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Fitzwater spot on the map
Rated from the USDA soil survey record for Fitzwater-Rock outcrop complex, 20 to 60 percent north slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Note Moderate engineering plasticity index (10).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 27 in (68 cm)).
- Note Typically starts about 33 in (84 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 75% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA1 A very cobbly loam layer about 0 to 3 in down: about 15% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA2 A very gravelly sandy loam layer about 3 to 7 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBw An extremely gravelly sandy loam layer about 7 to 33 in down: about 16% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layerCbest layer An extremely gravelly sandy loam layer about 33 to 60 in down: about 15% clay, moderate plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The sandy layer (C), 33 to 60 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; slightly hard, firm, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and residuum derived from volcanic rock such as basalt or welded tuff.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon, northeastern California, and northwestern Nevada. These soils are moderately extensive. MLRA 23.
USDA, geographic setting: Fitzwater soils are on plateaus, canyons, hills and mountains. They typically occur on backslope positions. These soils formed in colluvium and residuum derived from basalt or tuff. Slopes are 0 to 70 percent. Elevations range from 1,250 to 2,290 meters. The climate is semiarid and characterized by cold, moist winters and warm, dry summers. The mean annual precipitation is 250 to 400 mm, the mean annual temperature is 4 to 7 degrees C, and the frost-free period is 50 to 90 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
See it on the map
Open a Fitzwater spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 60%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Fitzwater-Rock outcrop complex, 20 to 60 percent north slopes, map unit 311 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Fitzwater(revised 12/2022), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, frigid Aridic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.