Enko soil
Wild-clay potential
Weak indication
Weak indication: no layer of Enko shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Enko soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Enko sandy loam, 0 to 6 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 13% clay.
- Note Moderate engineering plasticity index (8).
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 25 in (63 cm)).
- Note Typically starts about 35 in (89 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilA A sandy loam layer about 0 to 2 in down: about 10% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerBw A sandy loam layer about 2 to 11 in down: about 12% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Sandy layerBq A sandy loam layer about 11 to 35 in down: about 11% clay, moderate plasticity when wet, pale yellow when moist. Weak indication
- Sandy layerBkqbest layer A paragravelly sandy loam layer about 35 to 60 in down: about 13% clay, moderate plasticity when wet, pale yellow when moist. Weak indication
What it looks like raw
The sandy layer (Bkq), 35 to 60 in down in the typical profile: pale yellow (2.5Y 8/2), olive (5Y 5/3) moist; hard, firm and brittle, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from mixed volcanic rock with an influence of eolian material.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: Northeastern Nevada, south-central Oregon, and southwestern Idaho. These soils are extensive with about 276,000 acres of the series mapped to date. The series concept and main acreage is in MLRA 25, while other acreage occurs in MLRAs 23, 24 and 28B.
USDA, geographic setting: Enko soils are on fan remnants, inset fans, fan aprons, fan skirts, and swales. These soils formed in alluvium derived from mixed rocks with a component of loess and volcanic ash. Slopes are 0 to 30 percent. Elevations range from 1,250 to 2,075 meters in Nevada and Oregon, and range to 825 meters on north slopes in Idaho. The climate is semiarid with cool, moist winters and warm, dry summers. The mean annual precipitation is 200 to 280 mm, the mean annual temperature is 7 to 11 degrees C., and the frost-free period is 80 to 140 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Enko sandy loam, 0 to 6 percent slopes, map unit 290 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Enko(revised 01/2019), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Durinodic Xeric Haplocambids
- Rated with rule version 2026-09-28.1; the method is on the About page.