Embal soil
Wild-clay potential
Weak indication
Weak indication: no layer of Embal shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Embal soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Embal sandy loam, 0 to 3 percent slopes (Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts about 30 in (76 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 25% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A sandy loam layer about 0 to 20 in down: about 12% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2 A sandy loam layer about 20 to 30 in down: about 15% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH3best layer A gravelly sandy loam layer about 30 to 60 in down: about 15% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The sandy layer (H3), 30 to 60 in down in the typical profile: light brownish gray (10YR 6/2), very dark grayish brown (10YR 3/2) moist; slightly hard, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from basalt, welded tuff and volcanic ash.
- USDA family particle-size class: ashy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties; Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: Central Oregon. These soils are not extensive with about 2,500 acres of the series mapped to date. MLRA 23.
USDA, geographic setting: Embal soils are on flood plains, stream terraces, and drainageways. These soils formed in alluvium derived from volcanic ash and volcanic rocks. Slopes are 0 to 5 percent. Elevations range from 1,220 to 1,495 meters. The climate is semiarid and characterized by cold, moist winters and warm, dry summers. The mean annual precipitation is typically 250 to 360 mm but may range down to 200 mm in some areas in Lake County, Oregon. The mean annual temperature is 6 to 7 degrees C, mean January temperatures are -3 to -2 degrees C, and mean July temperatures are 15 to 16 degrees C. The frost-free period is 50 to 90 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Moonbeam: Strong lead
- Swalesilver: Strong lead
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Embal sandy loam, 0 to 3 percent slopes, map unit 43A in Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties.
- Official Series Description: Embal(revised 02/2011), established.
- Taxonomic class: Ashy, glassy, frigid Vitritorrandic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.