Carvix soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 19 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Carvix soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Carvix silt loam, 0 to 5 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 26% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (10).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 41 in (104 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- TopsoilA A silt loam layer about 0 to 6 in down: about 18% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerBA A silt loam layer about 6 to 19 in down: about 24% clay, moderate plasticity when wet, brown when moist. Possible
- Clay subsoilBtbest layer A loam layer about 19 to 60 in down: about 26% clay, moderate plasticity when wet, brown when moist. Possible
What it looks like raw
The clay subsoil (Bt), 19 to 60 in down in the typical profile: brown (10YR 5/3), brown (10YR 4/3) moist; slightly hard, friable, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from mixed volcanic rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: Southeastern Oregon. These soils are moderately extensive. MLRA 23.
USDA, geographic setting: Carvix soils are on high stream terraces adjacent to intermittent streams. These soils formed in alluvium derived from volcanic rocks. Slopes are 0 to 8 percent. Elevation ranges from 1,220 to 1,650 meters. The climate is semiarid and characterized by cold, moist winters and warm, dry summers. The mean annual precipitation is 250 to 360 mm, the mean annual temperature is 6 to 7 degrees C., and the frost-free period is 50 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Carvix silt loam, 0 to 5 percent slopes, map unit 242 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Carvix(revised 12/2022), established.
- Taxonomic class: Fine-loamy, mixed, superactive, frigid Aridic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.