Borobey soil
Wild-clay potential
Weak indication
Weak indication: no layer of Borobey shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Borobey soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Borobey spot on the map
Rated from the USDA soil survey record for Borobey sandy loam, 2 to 15 percent slopes (Harney County Area, Oregon) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 8% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 33 in (83 cm)).
- Note Typically starts about 27 in (69 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 18% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A sandy loam layer about 0 to 3 in down: about 13% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2 A gravelly loam layer about 3 to 11 in down: about 13% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3 A sandy loam layer about 11 to 23 in down: about 13% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH4 A gravelly loamy sand layer about 23 to 27 in down: about 8% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerH5best layer A gravelly loamy sand layer about 27 to 60 in down: about 8% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The sandy layer (H5), 27 to 60 in down in the typical profile: pale brown (10YR 6/3), dark yellowish brown (10YR 3/4) moist; hard, firm and brittle, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium derived from igneous rock.
- USDA family particle-size class: ashy.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 7 map units in Oregon, in these survey areas: Harney County Area, Oregon; Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties; Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: Central Oregon. These soils are moderately extensive. MLRA 23.
USDA, geographic setting: Borobey soils are on valley floors, lake terraces, and depressions on lava plateaus. These soils formed in pumiceous volcanic ash over alluvium derived from volcanic rocks. Slopes are 0 to 15 percent. Elevations range from 1,280 to 1,620 meters. The climate is semiarid and characterized by cold, moist winters and warm, dry summers. The mean annual precipitation is 8 to 12 inches. The mean annual temperature is 6 to 7 degrees C., mean January temperature is -3 to -2 degrees C., and the mean July temperature is 15 to 16 degrees C. The frost-free period is 50 to 90 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Moonbeam: Strong lead
- Swalesilver: Strong lead
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
See it on the map
Open a Borobey spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Borobey sandy loam, 2 to 15 percent slopes, map unit 41 in Harney County Area, Oregon.
- Official Series Description: Borobey(revised 12/2010), established.
- Taxonomic class: Ashy, glassy, frigid Vitritorrandic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.