Abert soil
Wild-clay potential
Weak indication
Weak indication: no layer of Abert shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Abert soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Abert ashy loamy sand, 0 to 2 percent slopes (Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (2): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 25 in (63 cm)).
- Note Typically starts about 35 in (89 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilA An ashy loamy sand layer about 0 to 2 in down: about 5% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBw An ashy sandy loam layer about 2 to 8 in down: about 10% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layer2Bk An ashy loam layer about 8 to 13 in down: about 15% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Loamy layer2Bkn An ashy silt loam layer about 13 to 25 in down: about 20% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layer2Bknz An ashy silt loam layer about 25 to 35 in down: about 18% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Sandy layer3Cbest layer A gravelly ashy loamy sand layer about 35 to 60 in down: about 5% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The sandy layer (3C), 35 to 60 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; extremely hard, very firm, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: eolian deposits derived from volcanic ash over lacustrine deposits derived from mixed volcanic rock and volcanic ash.
- USDA family particle-size class: ashy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: South-central Oregon. These soils are moderately extensive. MLRA 23.
USDA, geographic setting: Abert soils are on lakebeds. These soils formed in eolian material and lacustrine deposits derived from volcanic ash over lacustrine deposits derived from mixed volcanic rocks and volcanic ash. The source of the volcanic ash is ancestral Mt. Mazama. Slopes are 0 to 2 percent. Elevations range from 1,280 to 1,500 meters. The climate is semiarid and characterized by cold, moist winters and warm, dry summers. The mean annual precipitation is 200 to 250 mm, mean annual temperature is 6 to 7 degrees C., and the frost-free period is 50 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alyan: Strong lead
- Chancelakes: Strong lead
- Connleyhills: Strong lead
- Hayespring: Strong lead
- Moonbeam: Strong lead
- Overallflat: Strong lead
- Silverash: Strong lead
- Swalesilver: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Abert ashy loamy sand, 0 to 2 percent slopes, map unit 200 in Lake County, Oregon, Northern Part, Parts of Lake and Klamath Counties.
- Official Series Description: Abert(revised 11/2010), established.
- Taxonomic class: Ashy, glassy, frigid Sodic Xeric Haplocambids
- Rated with rule version 2026-09-28.1; the method is on the About page.