Willdin soil
Wild-clay potential
Weak indication
Weak indication: no layer of Willdin shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Willdin soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Willdin spot on the map
Rated from the USDA soil survey record for Willdin channery silt loam, 2 to 8 percent slopes (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 18% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (11).
- Note Thick enough to investigate (about 37 in (94 cm)).
- Note Typically starts within about 20 in (51 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A channery silt loam layer about 0 to 8 in down: about 14% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBw A channery silt loam layer about 8 to 16 in down: about 16% clay, moderate plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerE A channery silt loam layer about 16 to 20 in down: about 15% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerBxbest layer A channery loam layer about 20 to 57 in down: about 18% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Sandy layerC A very channery silt loam layer about 57 to 72 in down: about 14% clay, moderate plasticity when wet, brown when moist. Weak indication
What it looks like raw
The loamy layer (Bx), 20 to 57 in down in the typical profile: dark brown (10YR 3/3); firm and brittle. Raw colour is not fired colour.
About the soil
- Parent material: brownish loamy till derived from sandstone and siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 6 map units in New York, in these survey areas: Delaware County, New York; Otsego County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Higher elevations of MLRA 140. The series is moderately extensive.
USDA, geographic setting: Willdin soils are on uplands of glaciated dissected plateaus and till plains and are mainly on slightly convex hilltops and hillsides. Slope is commonly from 0 to 25 percent but the range includes up to 35 percent. The soils developed in firm till derived from sandstone, siltstone, and shale. Annual air temperature ranges from 4 to 9 degrees C (39 to 48 degrees F). Annual precipitation ranges from 825 to 1790 mm (32 to 70 in) and the frost free days range from 110 to 155 days. Elevation ranges from 425 to 1100 m (1394 to 3608 ft) above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alden: Possible
- Canandaigua: Possible
- Bath: Weak indication
- Chenango: Weak indication
- Lewbath: Weak indication
- Lordstown: Weak indication
- Mardin: Weak indication
- Mongaup: Weak indication
See it on the map
Open a Willdin spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Willdin channery silt loam, 2 to 8 percent slopes, map unit WhB in Delaware County, New York.
- Official Series Description: Willdin(revised 01/2016), established.
- Taxonomic class: Coarse-loamy, mixed, active, frigid Typic Fragiudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.