Mongaup soil
Wild-clay potential
Weak indication
Weak indication: no layer of Mongaup shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Mongaup soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Mongaup spot on the map
Rated from the USDA soil survey record for Mongaup channery loam, 2 to 8 percent slopes (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Bedrock or unweathered rock, not a soil layer to dig for clay.
Layer by layer
- TopsoilAp A channery loam layer about 0 to 5 in down: about 12% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerBw1 A channery silt loam layer about 5 to 12 in down: about 12% clay, low plasticity when wet, yellowish red when moist. Weak indication
- Sandy layerBw2 A channery silt loam layer about 12 to 20 in down: about 12% clay, low plasticity when wet, strong brown when moist. Weak indication
- Sandy layerBC A very channery silt loam layer about 20 to 28 in down: about 12% clay, low plasticity when wet, brown when moist. Weak indication
- Bedrock2Rbest layer Bedrock about 28 to 38 in down: no clay layer to dig. Weak indication
What it looks like raw
The bedrock (2R), 28 to 38 in down in the typical profile: massive, hard grayish brown sandstone bedrock. Raw colour is not fired colour.
About the soil
- Parent material: loamy till derived from sandstone, siltstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 28 in (71 cm) down.
Where it is mapped
Seen on the map as the most common soil in 7 map units in New York, in these survey areas: Delaware County, New York; Otsego County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Catskill Mountain area of east- central New York and higher elevations of the Appalachian Plateau in southern New York. MLRA 140. The series is moderately extensive.
USDA, geographic setting: Mongaup soils are nearly level to very steep soils with slope ranging from 0 to 70 percent. These soils formed in acid till on bedrock controlled uplands. The climate is humid and is cool in summer and cold in winter. Annual air temperature ranges from 40 to 46 degrees F. Annual precipitation is 39 to 58 inches and the frost-free season ranges from about 100 to 130 days. Elevation ranges from 1000 to 2400 feet above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alden: Possible
- Canandaigua: Possible
- Bath: Weak indication
- Chenango: Weak indication
- Lewbath: Weak indication
- Lordstown: Weak indication
- Mardin: Weak indication
- Norchip: Weak indication
See it on the map
Open a Mongaup spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Mongaup channery loam, 2 to 8 percent slopes, map unit MnB in Delaware County, New York.
- Official Series Description: Mongaup(revised 01/2011), established.
- Taxonomic class: Coarse-loamy, mixed, active, frigid Typic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.