Bath soil
Wild-clay potential
Weak indication
Weak indication: no layer of Bath shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bath soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Bath channery silt loam, 3 to 8 percent slopes (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 16% clay.
- Note Moderate engineering plasticity index (10).
- Note Thick enough to investigate (about 23 in (58 cm)).
- Note Typically starts about 29 in (74 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 35% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilAp A channery silt loam layer about 0 to 9 in down: about 12% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBw1 A channery silt loam layer about 9 to 15 in down: about 12% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerBw2 A channery loam layer about 15 to 25 in down: about 12% clay, moderate plasticity when wet, light olive brown when moist. Weak indication
- Sandy layerE A channery loam layer about 25 to 29 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBxbest layer A very channery silt loam layer about 29 to 52 in down: about 16% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layerC A very channery silt loam layer about 52 to 72 in down: about 14% clay, moderate plasticity when wet, light olive brown when moist. Weak indication
What it looks like raw
The sandy layer (Bx), 29 to 52 in down in the typical profile: brown (10YR 4/3), and brown (10YR 5/3); very channery silt loam; firm; brittle. Raw colour is not fired colour.
About the soil
- Parent material: loamy till derived mainly from gray and brown siltstone, sandstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 8 map units in New York, in these survey areas: Delaware County, New York; Otsego County, New York; Schoharie County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Typically the Glaciated Allegheny Plateau in Pennsylvania and New York. Typically MLRA 140 but includes adjoining portions of MLRA 101 and MLRA 144A. The series is of moderate extent.
USDA, geographic setting: Bath soils are gently sloping to steep soils on uplands. Slope ranges from 0 to 60 percent. The soils formed in loamy till derived largely from gray and brown siltstone, sandstone and shale. The climate is temperate and humid. Mean annual precipitation commonly ranges from 795 to 1725 mm (31 to 68 in) but the range includes as high as 1790 mm (70 in) in some places; mean annual temperature ranges from 6 to 11 degrees C (43 to 52 degrees F). The frost-free season ranges from 105 to 180 days. Elevation typically ranges from 100 to 670 m ( 328 to 2,198 ft) but the range includes as high as 750 m (2460 ft) in some places.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Lakemont: Strong lead
- Phelps: Strong lead
- Holly: Promising
- Alden: Possible
- Canandaigua: Possible
- Lordstown: Weak indication
- Mardin: Weak indication
- Volusia: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bath channery silt loam, 3 to 8 percent slopes, map unit BtB in Delaware County, New York.
- Official Series Description: Bath(revised 10/2017), established.
- Taxonomic class: Coarse-loamy, mixed, active, mesic Typic Fragiudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.