Volusia soil
Wild-clay potential
Weak indication
Weak indication: no layer of Volusia shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Volusia soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Volusia spot on the map
Rated from the USDA soil survey record for Volusia channery silt loam, 0 to 3 percent slopes (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 21% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (13).
- Note Thick enough to investigate (about 25 in (63 cm)).
- Note Typically starts about 29 in (74 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A channery silt loam layer about 0 to 9 in down: about 18% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Loamy layerBw A channery silt loam layer about 9 to 15 in down: about 20% clay, moderate plasticity when wet, percent olive brown when moist. Weak indication
- Loamy layerEg A channery silt loam layer about 15 to 17 in down: about 18% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerBx1 A channery loam layer about 17 to 29 in down: about 22% clay, moderate plasticity when wet, light olive brown when moist. Weak indication
- Loamy layerBx2best layer A channery loam layer about 29 to 54 in down: about 21% clay, moderate plasticity when wet, olive brown when moist. Weak indication
- Loamy layerC A channery silt loam layer about 54 to 72 in down: about 20% clay, moderate plasticity when wet, olive when moist. Weak indication
What it looks like raw
The loamy layer (Bx2), 29 to 54 in down in the typical profile: olive brown (2.5Y 4/4); very channery loam; very firm; brittle. Raw colour is not fired colour.
About the soil
- Parent material: loamy till derived from interbedded sedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 9 map units in New York, in these survey areas: Delaware County, New York; Otsego County, New York; Schoharie County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Glaciated Allegheny Plateau of New York and northern Pennsylvania. MLRA 101, 139, 140, and 144A. The soil is extensive.
USDA, geographic setting: Volusia soils occupy long uniform slopes. Slope ranges from 0 to 35 percent. They are on lower valley sides and on broad divides of maturely dissected glaciated plateaus. The Volusia soils developed in firm basal till derived from siltstone, sandstone and brittle shale or slate. They are underlain by lacustrine materials in some areas. Mean annual precipitation typically ranges from 795 to 1725 mm (31 to 68 inches), but in some higher elevations it can range as high as 1790 mm (70 inches). Mean annual temperature typically ranges from 6 to 11 degrees C (43 to 52 degrees F), but in some higher elevations it can range as low as 4 degrees C (39 degrees F). Mean annual frost-free days ranges...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Lakemont: Strong lead
- Phelps: Strong lead
- Holly: Promising
- Alden: Possible
- Canandaigua: Possible
- Bath: Weak indication
- Lordstown: Weak indication
- Mardin: Weak indication
See it on the map
Open a Volusia spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Volusia channery silt loam, 0 to 3 percent slopes, map unit VoA in Delaware County, New York.
- Official Series Description: Volusia(revised 10/2017), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Aeric Fragiaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.