Lakemont soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 31 to 79 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lakemont soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Lakemont spot on the map
Rated from the USDA soil survey record for Lakemont and Madalin silty clay loams, 0 to 3 percent slopes (Schoharie County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 48 in (121 cm)).
- Note Typically starts about 31 in (79 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 0% by volume).
- Note High shrink-swell (linear extensibility about 6%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 10% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Clay-rich layerAp A silty clay loam layer about 0 to 6 in down: about 35% clay, moderate plasticity when wet, black when moist. Promising
- Clay-rich layerEg A silty clay loam layer about 6 to 10 in down: about 35% clay, moderate plasticity when wet, gray when moist. Promising
- Clay subsoilBtg1 A silty clay layer about 10 to 15 in down: about 48% clay, high plasticity when wet, gray when moist. Promising
- Clay subsoilBtg2 A silty clay layer about 15 to 31 in down: about 48% clay, high plasticity when wet, pinkish gray when moist. Strong lead
- Clay-rich layerCbest layer A silty clay layer about 31 to 79 in down: about 48% clay, high plasticity when wet, percent dark reddish gray when moist. Strong lead
What it looks like raw
The clay-rich layer (C), 31 to 79 in down in the typical profile: percent dark reddish gray (5YR 4/2), percent reddish brown (5YR 4/4); silty clay loam; firm. Raw colour is not fired colour.
About the soil
- Parent material: red clayey glaciolacustrine deposits derived from calcareous shale.
- USDA family mineralogy: illitic.
- USDA family particle-size class: fine.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in New York, in these survey areas: Schoharie County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Ontario Lake plain and the Mohawk Valley of New York, and locally in north-flowing valleys tributary to these major lowlands. MLRA's 101 and 140. The soil is moderately extensive.
USDA, geographic setting: Lakemont soils are on nearly level parts and slight depressions of lake plains. Slope ranges from 0 to 3 percent. The soil formed in clayey lake-deposited sediments. Mean annual temperature ranges from 46 to 50 degrees F., mean annual precipitation from 28 to 40 inches, and mean growing season from 140 to 190 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Phelps: Strong lead
- Holly: Promising
- Arnot: Weak indication
- Barbour: Weak indication
- Basher: Weak indication
- Bath: Weak indication
- Chippewa: Weak indication
- Lackawanna: Weak indication
See it on the map
Open a Lakemont spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 45%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lakemont and Madalin silty clay loams, 0 to 3 percent slopes, map unit LaA in Schoharie County, New York.
- Official Series Description: Lakemont(revised 01/2004), established.
- Taxonomic class: Fine, illitic, mesic Udollic Endoaqualfs
- Rated with rule version 2026-09-28.1; the method is on the About page.