Lackawanna soil
Wild-clay potential
Weak indication
Weak indication: no layer of Lackawanna shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lackawanna soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Lackawanna spot on the map
Rated from the USDA soil survey record for Lackawanna flaggy silt loam, 3 to 8 percent slopes (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Note Moderate engineering plasticity index (9).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 34 in (86 cm)).
- Note Typically starts about 26 in (66 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A flaggy silt loam layer about 0 to 7 in down: about 15% clay, moderate plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerBw1 A flaggy silt loam layer about 7 to 17 in down: about 15% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerBw2 A flaggy loam layer about 17 to 26 in down: about 14% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerBxbest layer A flaggy loam layer about 26 to 60 in down: about 15% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerC A very flaggy loam layer about 60 to 72 in down: about 13% clay, moderate plasticity when wet, weak red when moist. Weak indication
What it looks like raw
The sandy layer (Bx), 26 to 60 in down in the typical profile: reddish brown (2.5YR 4/4); channery loam; very firm, brittle, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy till derived mainly from reddish sandstone, siltstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 10 map units in New York, in these survey areas: Delaware County, New York; Schoharie County, New York.
By state: wild clay in New York.
USDA, distribution and extent: The glaciated Allegheny Plateau of southern New York, northern Pennsylvania and New Jersey. Almost all of the acreage occurs in MLRA 140. The remaining acreage occurs in transitional areas just outside the MLRA 140 boundary in adjacent MLRAs. The series is extensive.
USDA, geographic setting: Lackawanna soils are on nearly level to steep glaciated uplands. Slope ranges from 0 to 55 percent. The soils developed in firm till derived from reddish sandstone, siltstone, and shale. Mean annual temperature ranges from 6 to 11 degrees C (43 to 52 degrees F). Mean annual precipitation ranges from 795 to 1725 mm (31 to 68 in), and mean annual frost-free season ranges from 105 to 180 days. These soils commonly occur at elevations between 100 and 670 m (328 and 2,198 feet), but have been mapped as high as 750 m (2,460 feet) in some areas.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Lakemont: Strong lead
- Phelps: Strong lead
- Holly: Promising
- Barbour: Weak indication
- Basher: Weak indication
- Bath: Weak indication
- Lordstown: Weak indication
- Mardin: Weak indication
See it on the map
Open a Lackawanna spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lackawanna flaggy silt loam, 3 to 8 percent slopes, map unit LaB in Delaware County, New York.
- Official Series Description: Lackawanna(revised 09/2015), established.
- Taxonomic class: Coarse-loamy, mixed, active, mesic Typic Fragiudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.