Lordstown soil
Wild-clay potential
Weak indication
Weak indication: no layer of Lordstown shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lordstown soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Lordstown spot on the map
Rated from the USDA soil survey record for Lordstown channery silt loam, 2 to 8 percent slopes (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 12% clay.
- Note Moderate engineering plasticity index (7).
- Note Moderate thickness (about 10 in (25 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 20% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A channery silt loam layer about 0 to 7 in down: about 14% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBw1best layer A channery silt loam layer about 7 to 17 in down: about 12% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerBw2 A channery silt loam layer about 17 to 26 in down: about 14% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerC A very channery silt loam layer about 26 to 30 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Bedrock2R Bedrock about 30 to 40 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (Bw1), 7 to 17 in down in the typical profile: yellowish brown (10YR 5/4); channery silt loam; very friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy till derived from sandstone and siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 30 in (76 cm) down.
Where it is mapped
Seen on the map as the most common soil in 18 map units in New York, Pennsylvania, in these survey areas: Delaware County, New York; Otsego County, New York; Schoharie County, New York; Warren and Forest Counties, Pennsylvania.
By state: wild clay in New York,wild clay in Pennsylvania.
USDA, distribution and extent: The glaciated Allegheny Plateau of southern New York, northern New Jersey, Pennsylvania and Ohio, and Vermont. MLRAs 101, 127, 139, 140, and 142. The series is extensive.
USDA, geographic setting: Lordstown soils are nearly level to very steep soils with slopes ranging from 0 to 90 percent. These soils formed in till and cryoturbated material derived from siltstone and sandstone on bedrock controlled landforms of glaciated dissected plateaus. Mean annual temperature ranges from 6 to 11 degrees C (43 through 52 degrees F). Mean annual precipitation ranges from 795 through 1725 mm (31 to 68 in), and mean annual frost-free season ranges from 105 to 180 days. These soils generally occur at elevations between 100 and 670 m (328 and 2,198 ft), but have been mapped as high as 750 m (2,460 ft) in some areas.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Armagh: Strong lead
- Cavode: Strong lead
- Lakemont: Strong lead
- Phelps: Strong lead
- Brinkerton: Promising
- Ernest: Promising
- Holly: Promising
- Shelmadine: Promising
See it on the map
Open a Lordstown spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lordstown channery silt loam, 2 to 8 percent slopes, map unit LoB in Delaware County, New York.
- Official Series Description: Lordstown(revised 06/2016), established.
- Taxonomic class: Coarse-loamy, mixed, active, mesic Typic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.