Brinkerton soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 8 to 21 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Brinkerton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Brinkerton spot on the map
Rated from the USDA soil survey record for Brinkerton soils, 3 to 8 percent slopes (Warren and Forest Counties, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note USDA labels this a "Btg" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (21): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 1 in down, not a clay body. Weak indication
- TopsoilA A mucky silt loam layer about 1 to 3 in down: about 23% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerEg A silt loam layer about 3 to 8 in down: about 23% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBtgbest layer A silty clay loam layer about 8 to 21 in down: about 30% clay, high plasticity when wet, grayish brown when moist. Promising
- Clay subsoilBtxg A silt loam layer about 21 to 42 in down: about 25% clay, moderate plasticity when wet, grayish brown when moist. Possible
- Loamy layerBC A channery silt loam layer about 42 to 65 in down: about 25% clay, moderate plasticity when wet, brown when moist. Weak indication
What it looks like raw
The clay subsoil (Btg), 8 to 21 in down in the typical profile: grayish brown (2.5Y 5/2); firm, sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: acid fine-silty colluvium derived from shale and siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 12 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Huntingdon County, Pennsylvania; Lebanon County, Pennsylvania; Lehigh County, Pennsylvania; Northampton County, Pennsylvania; Warren and Forest Counties, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Pennsylvania, Maryland, New York, and West Virginia. MLRAs 124, 125, 126, 127, 128, 130A, 139, 140, 144A, 147, and 148. The series is of large extent with approximately 405,000 acres mapped to date.
USDA, geographic setting: Brinkerton soils are on nearly level to concave toeslopes, footslopes, and around heads of drainageways. Slopes range from 0 to 15 percent. The soils developed in medium textured colluvium from acid gray shale and siltstone. Mean annual precipitation ranges from about 889 to 1270 mm; mean annual air temperature ranges from 8 to 13 degrees C.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hagerstown: Strong lead
- Armagh: Strong lead
- Cavode: Strong lead
- Edom: Strong lead
- Hublersburg: Strong lead
- Opequon: Strong lead
- Purdy: Strong lead
- Watchung: Strong lead
See it on the map
Open a Brinkerton spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 66%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Brinkerton soils, 3 to 8 percent slopes, map unit BkB in Warren and Forest Counties, Pennsylvania.
- Official Series Description: Brinkerton(revised 04/2021), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Typic Fragiaqualfs
- Rated with rule version 2026-09-28.1; the method is on the About page.