Hagerstown soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 21 to 56 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Hagerstown soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Hagerstown spot on the map
Rated from the USDA soil survey record for Hagerstown silt loam, 0 to 3 percent slopes (Centre County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 55% clay in the fine-earth portion.
- Note USDA labels this a "Bt2" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (40): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 35 in (89 cm)).
- Note Typically starts within about 21 in (53 cm) of the surface.
- Note Few rock fragments (about 13% by volume).
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 10 in down: about 21% clay, moderate plasticity when wet, dark brown or brown when moist. Weak indication
- Clay subsoilBt1 A silty clay loam layer about 10 to 21 in down: about 37% clay, high plasticity when wet, yellowish red when moist. Strong lead
- Clay subsoilBt2best layer A silty clay layer about 21 to 56 in down: about 55% clay, high plasticity when wet, reddish brown when moist. Strong lead
- Clay-rich layerC A silty clay loam layer about 56 to 73 in down: about 38% clay, high plasticity when wet, yellowish red when moist. Promising
- BedrockR Bedrock about 73 to 83 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt2), 21 to 56 in down in the typical profile: reddish brown (2.5YR 4/4); silty clay; friable. Raw colour is not fired colour.
About the soil
- Parent material: clayey residuum weathered from limestone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: well drained.
- Lithic bedrock typically about 73 in (185 cm) down.
Where it is mapped
Seen on the map as the most common soil in 17 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Centre County, Pennsylvania; Lancaster County, Pennsylvania; Lebanon County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Pennsylvania, Maryland, Virginia, West Virginia, Kentucky and Tennessee; possibly Ohio, Indiana, and Missouri. The series is of large extent.
USDA, geographic setting: Hagerstown soils occupy valley floors and the adjacent hills. In some areas rock outcrops are common surface features. Most slopes are less than 15 percent but range up to 45 percent. The soils developed in materials weathered from hard gray limestone of rather high purity. The climate is temperate and moderately humid, with a mean annual temperature of 45 to 58 degrees F. and mean annual precipitation of 30 to 45 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Dunning: Strong lead
- Hublersburg: Strong lead
- Millheim: Strong lead
- Opequon: Strong lead
- Bowmansville: Promising
- Duffield: Promising
- Holly: Promising
See it on the map
Open a Hagerstown spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Hagerstown silt loam, 0 to 3 percent slopes, map unit HaA in Centre County, Pennsylvania.
- Official Series Description: Hagerstown(revised 06/2006), established.
- Taxonomic class: Fine, mixed, semiactive, mesic Typic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.