Dunning soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 15 to 66 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Dunning soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Dunning spot on the map
Rated from the USDA soil survey record for Dunning silty clay loam (Centre County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (30): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 51 in (130 cm)).
- Note Typically starts within about 15 in (38 cm) of the surface.
- Note Few rock fragments (about 14% by volume).
Layer by layer
- Loamy layerH1 A silty clay loam layer about 0 to 15 in down: about 34% clay, moderate plasticity when wet, very dark gray when moist. Promising
- Clay-rich layerH2best layer A silty clay layer about 15 to 66 in down: about 48% clay, high plasticity when wet, dark gray when moist. Strong lead
What it looks like raw
The clay-rich layer (H2), 15 to 66 in down in the typical profile: dark gray (2.5Y 4/1); very firm, moderately sticky, moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: recent alluvium derived from limestone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 2 map units in District of Columbia, Pennsylvania, in these survey areas: Centre County, Pennsylvania; District of Columbia.
By state: wild clay in District of Columbia,wild clay in Pennsylvania.
USDA, distribution and extent: Limestone areas in Virginia, Kentucky, Tennessee, West Virginia, Maryland, southern Missouri, Pennsylvania, the upper valley of East Tennessee and possibly Ohio. The series is of moderate extent.
USDA, geographic setting: Dunning soils formed in slack water and fine textured alluvium washed from limestone hillsides. Slopes range from 0 to 3 percent. Mean annual precipitation is about 47 inches and mean annual air temperature is about 55 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Christiana: Strong lead
- Hagerstown: Strong lead
- Hublersburg: Strong lead
- Millheim: Strong lead
- Opequon: Strong lead
- Lindside: Promising
- Chillum: Promising
- Keyport: Promising
See it on the map
Open a Dunning spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Dunning silty clay loam, map unit Du in Centre County, Pennsylvania.
- Official Series Description: Dunning(revised 01/2010), established.
- Taxonomic class: Fine, mixed, active, mesic Fluvaquentic Endoaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.