Opequon soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 6 to 16 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Opequon soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Opequon spot on the map
Rated from the USDA soil survey record for Opequon-Hagerstown complex, steep (Centre County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 55% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (27.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 10 in (26 cm)).
- Note Typically starts within about 6 in (15 cm) of the surface.
- Note Few rock fragments (about 6% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
Layer by layer
- Clay-rich layerH1 A silty clay loam layer about 0 to 6 in down: about 36% clay, high plasticity when wet, dark brown when moist. Strong lead
- Clay-rich layerH2best layer A silty clay layer about 6 to 16 in down: about 55% clay, high plasticity when wet, yellowish red when moist. Strong lead
- BedrockH3 Bedrock about 16 to 20 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (H2), 6 to 16 in down in the typical profile: yellowish red (5YR 4/6); firm, sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from limestone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: clayey.
- Drainage: well drained.
- Lithic bedrock typically about 16 in (41 cm) down.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Pennsylvania, in these survey areas: Centre County, Pennsylvania; Huntingdon County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Distribution: Kentucky, Maryland, Missouri, Ohio, Pennsylvania, Virginia, and West Virginia.
USDA, geographic setting: Landscapes: Limestone uplands; mountains, hills, valleys, karst
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hublersburg: Strong lead
- Dunning: Strong lead
- Edom: Strong lead
- Hagerstown: Strong lead
- Millheim: Strong lead
- Purdy: Strong lead
- Brinkerton: Promising
- Ernest: Promising
See it on the map
Open a Opequon spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 40%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Opequon-Hagerstown complex, steep, map unit ORF in Centre County, Pennsylvania.
- Official Series Description: Opequon(revised 04/2014), established.
- Taxonomic class: Clayey, mixed, active, mesic Lithic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.