Lindside soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 13 to 46 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lindside soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Lindside spot on the map
Rated from the USDA soil survey record for Lindside silt loam (Lebanon County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (11).
- Note Thick enough to investigate (about 33 in (84 cm)).
- Note Typically starts within about 13 in (33 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 13 in down: about 21% clay, moderate plasticity when wet, dark grayish brown when moist. Possible
- Loamy layerH2best layer A silty clay loam layer about 13 to 46 in down: about 30% clay, moderate plasticity when wet, brown when moist. Promising
- Loamy layerH3 A gravelly sandy loam layer about 46 to 65 in down: about 26% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
What it looks like raw
The loamy layer (H2), 13 to 46 in down in the typical profile: brown (10YR 4/3); firm. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from sedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 7 map units in District of Columbia, Maryland, Pennsylvania, in these survey areas: Baltimore County, Maryland; Centre County, Pennsylvania; Chester County, Pennsylvania; District of Columbia; Lancaster County, Pennsylvania; Lebanon County, Pennsylvania.
By state: wild clay in District of Columbia,wild clay in Maryland,wild clay in Pennsylvania.
USDA, distribution and extent: Distribution: West Virginia, Indiana, Kentucky, Maryland, Ohio, Pennsylvania, Tennessee, Virginia, Alabama
USDA, geographic setting: Landscape: River valley or Hills
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Hagerstown: Strong lead
- Christiana: Strong lead
- Dunning: Strong lead
- Benevola: Strong lead
- Cumberstone: Strong lead
- Hublersburg: Strong lead
- Jackland: Strong lead
See it on the map
Open a Lindside spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lindside silt loam, map unit Ls in Lebanon County, Pennsylvania.
- Official Series Description: Lindside(revised 09/2015), established.
- Taxonomic class: Fine-silty, mixed, active, mesic Fluvaquentic Eutrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.