Watchung soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 9 to 33 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Watchung soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Watchung spot on the map
Rated from the USDA soil survey record for Watchung silt loam, 0 to 3 percent slopes (Harford County Area, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Note USDA labels this a "Btg" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (36): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 24 in (61 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
- Note High shrink-swell (linear extensibility about 6.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA A silt loam layer about 0 to 9 in down: about 22% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBtgbest layer A silty clay layer about 9 to 33 in down: about 45% clay, high plasticity when wet, gray when moist. Strong lead
- Clay-rich layerBC A silty clay layer about 33 to 52 in down: about 42% clay, high plasticity when wet, yellowish brown when moist. Strong lead
- Loamy layerC A silt loam layer about 52 to 80 in down: about 25% clay, high plasticity when wet, strong brown when moist. Weak indication
What it looks like raw
The clay subsoil (Btg), 9 to 33 in down in the typical profile: gray (10YR 5/1); very firm, sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: clayey residuum weathered from gabbro or other mafic rocks.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: poorly drained.
- Lithic bedrock typically about 98 in (250 cm) down.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 21 map units in Delaware, Maryland, Pennsylvania, in these survey areas: Baltimore County, Maryland; Cecil County, Maryland; Chester County, Pennsylvania; Delaware County, Pennsylvania; Harford County Area, Maryland; Lancaster County, Pennsylvania; Lebanon County, Pennsylvania; Montgomery County, Pennsylvania; New Castle County, Delaware.
By state: wild clay in Delaware,wild clay in Maryland,wild clay in Pennsylvania.
USDA, distribution and extent: New Jersey, Pennsylvania, Delaware and Maryland. The series is of moderate extent.
USDA, geographic setting: Watchung soils are nearly level to gently sloping soils on upland flats and depressions in the northern Piedmont Plateau. Slopes are less than 8 percent. The soils formed in residuum from basic rocks, most commonly gabbro, diabase and diorite. The climate is temperate and humid, with a mean annual temperature of 45 to 55 degrees F., and mean annual precipitation of 40 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Montalto: Strong lead
- Christiana: Strong lead
- Hagerstown: Strong lead
- Talleyville: Strong lead
- Benevola: Strong lead
- Cumberstone: Strong lead
- Jackland: Strong lead
- Kelly: Strong lead
See it on the map
Open a Watchung spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Watchung silt loam, 0 to 3 percent slopes, map unit WaA in Harford County Area, Maryland.
- Official Series Description: Watchung(revised 02/2008), established.
- Taxonomic class: Fine, smectitic, mesic Typic Albaqualfs
- Rated with rule version 2026-09-28.1; the method is on the About page.