Kelly soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 9 to 38 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Kelly soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Kelly silt loam, 3 to 8 percent slopes (Harford County Area, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (33): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 29 in (73 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 7% by volume).
- Note High shrink-swell (linear extensibility about 6.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 9 in down: about 19% clay, moderate plasticity when wet, grayish brown when moist. Possible
- Clay-rich layerH2best layer A silty clay layer about 9 to 38 in down: about 45% clay, high plasticity when wet, dark yellowish brown when moist. Strong lead
- Loamy layerH3 A very gravelly silt loam layer about 38 to 45 in down: about 25% clay, moderate plasticity when wet, white when moist. Weak indication
- BedrockR Bedrock about 45 to 80 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (H2), 9 to 38 in down in the typical profile: dark yellowish brown (10YR 4/6); firm, moderately sticky, moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: clayey residuum weathered from diabase.
- USDA family mineralogy: vermiculitic.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
- Lithic bedrock typically about 45 in (114 cm) down.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Maryland, Virginia, in these survey areas: Fauquier County, Virginia; Harford County Area, Maryland.
By state: wild clay in Maryland,wild clay in Virginia.
USDA, distribution and extent: Culpeper basin in Virginia and Maryland, possibly the southern end of the Gettysburg basin of Maryland. The series is of moderate extent.
USDA, geographic setting: Kelly soils formed in residuum weathered from gray to brown hornfel and granulite and are on level to gently sloping uplands of the Culpeper basin in the northern Piedmont Plateau. Slopes range from 0 to 10 percent. Mean annual temperature ranges from 53 to 57 degrees F., and mean annual precipitation ranges from 38 to 45 inches, frost free days range from 165 to 203, and elevation ranges from 200 feet to 600 feet above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Montalto: Strong lead
- Albano: Strong lead
- Appling: Strong lead
- Cecil: Strong lead
- Clover: Strong lead
- Dulles: Strong lead
- Fletcherville: Strong lead
- Jackland: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Kelly silt loam, 3 to 8 percent slopes, map unit KeB in Harford County Area, Maryland.
- Official Series Description: Kelly(revised 01/2006), established.
- Taxonomic class: Fine, vermiculitic, mesic Aquic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.