Dulles soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 8 to 34 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Dulles soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Dulles silt loam, 0 to 2 percent slopes (Fauquier County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 36% clay in the fine-earth portion.
- Note USDA labels this a "Bt1" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (25): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 26 in (66 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Note Few rock fragments (about 4% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 8 in down: about 18% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBt1best layer A silty clay loam layer about 8 to 34 in down: about 36% clay, high plasticity when wet, yellowish brown when moist. Strong lead
- Clay subsoilBt2 A clay layer about 34 to 41 in down: about 50% clay, high plasticity when wet, yellowish brown when moist. Strong lead
- BedrockCr Bedrock about 41 to 59 in down: no clay layer to dig. Weak indication
- BedrockR Bedrock about 59 to 69 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt1), 8 to 34 in down in the typical profile: yellowish brown (10YR 5/6). Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from shale and siltstone.
- USDA family mineralogy: vermiculitic.
- USDA family particle-size class: fine.
- Drainage: somewhat poorly drained.
- Paralithic bedrock typically about 41 in (104 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Virginia, in these survey areas: Fauquier County, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Culpeper Basin of Virginia and the southwestern part of the Gettysburg Basin of Pennsylvania and Maryland. The series is of small extent.
USDA, geographic setting: Dulles soils are on broad nearly level uplands, and concave lowlands such as toeslopes and heads of drainageways in Triassic-Jurassic Basins of the Northern Piedmont Plateau. Slope gradients are typically 0 to 4 percent. The soils formed in slope creep and in residuum from red, fine grained sandstone, siltstone and shale. The source of the colluvium is Pleistocene aged mass wastage of old alluvial cappings and residual red bedrock materials. Elevations range from 180 to 300 ft. The mean annual temperature ranges from 50 to 57 degrees F and mean annual precipitation ranges from 38 to 44 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Albano: Strong lead
- Appling: Strong lead
- Cecil: Strong lead
- Clover: Strong lead
- Fletcherville: Strong lead
- Jackland: Strong lead
- Kelly: Strong lead
- Lignum: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Dulles silt loam, 0 to 2 percent slopes, map unit 78A in Fauquier County, Virginia.
- Official Series Description: Dulles(revised 01/2006), established.
- Taxonomic class: Fine, vermiculitic, mesic Aquultic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.