Fletcherville soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 18 to 32 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Fletcherville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Fletcherville spot on the map
Rated from the USDA soil survey record for Fletcherville-Myersville complex, 2 to 7 percent slopes (Fauquier County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 55% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (45): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 14 in (35 cm)).
- Note Typically starts within about 18 in (46 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
- Note High shrink-swell (linear extensibility about 7%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Sandy layerH1 A loam layer about 0 to 6 in down: about 15% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay-rich layerH2 A clay loam layer about 6 to 18 in down: about 35% clay, high plasticity when wet, brownish yellow when moist. Strong lead
- Clay-rich layerH3best layer A clay layer about 18 to 32 in down: about 55% clay, high plasticity when wet, light yellowish brown when moist. Strong lead
- Loamy layerH4 A clay loam layer about 32 to 42 in down: about 30% clay, high plasticity when wet, reddish yellow when moist. Promising
- BedrockH5 Bedrock about 42 to 46 in down: no clay layer to dig. Weak indication
- BedrockH6 Bedrock about 46 to 56 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (H3), 18 to 32 in down in the typical profile: light yellowish brown (2.5Y 6/4); firm, very sticky, very plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from greenstone.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
- Paralithic bedrock typically about 42 in (107 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Virginia, in these survey areas: Fauquier County, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: MLRA 130A, 130 and 136 in Virginia. The soils are of limited extent.
USDA, geographic setting: Fletcherville soils formed in residuum of greenstone schist and are on summits, shoulders and backslopes of headslopes on ridges on the foot hills of the Blue Ridge Mountains. Slope gradients range from 0 to 15 percent. Mean air temperature ranges from 53 to 57 degrees F, mean annual precipitation ranges from 38 to 44 inches, frost free days range from 165 to 203, and elevation ranges from 250 to 850 feet above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Albano: Strong lead
- Appling: Strong lead
- Cecil: Strong lead
- Clover: Strong lead
- Dulles: Strong lead
- Jackland: Strong lead
- Kelly: Strong lead
- Lignum: Strong lead
See it on the map
Open a Fletcherville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Fletcherville-Myersville complex, 2 to 7 percent slopes, map unit 48B in Fauquier County, Virginia.
- Official Series Description: Fletcherville(revised 09/2016), established.
- Taxonomic class: Fine, smectitic, mesic Oxyaquic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.