Jackland soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 15 to 38 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Jackland soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Jackland spot on the map
Rated from the USDA soil survey record for Jackland silt loam, 2 to 7 percent slopes (Prince William County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 50% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (41): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 23 in (58 cm)).
- Note Typically starts within about 15 in (38 cm) of the surface.
- Note Few rock fragments (about 8% by volume).
- Note High shrink-swell (linear extensibility about 17%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 10 in down: about 21% clay, moderate plasticity when wet, yellowish brown when moist. Possible
- Loamy layerH2 A silt loam layer about 10 to 15 in down: about 26% clay, high plasticity when wet, dark yellowish brown when moist. Weak indication
- Clay-rich layerH3best layer A clay layer about 15 to 38 in down: about 50% clay, high plasticity when wet, dark yellowish brown when moist. Strong lead
- Loamy layerH4 A loam layer about 38 to 60 in down: about 25% clay, high plasticity when wet, yellowish brown when moist. Possible
What it looks like raw
The clay-rich layer (H3), 15 to 38 in down in the typical profile: dark yellowish brown (10YR 4/4); very firm, very plastic, very sticky. Raw colour is not fired colour.
About the soil
- Parent material: Mixed mafic residuum.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 6 map units in Maryland, North Carolina, Virginia, in these survey areas: Baltimore County, Maryland; Fauquier County, Virginia; Forsyth County, North Carolina; Prince William County, Virginia.
By state: wild clay in Maryland,wild clay in North Carolina,wild clay in Virginia.
USDA, distribution and extent: Northern Virginia Maryland and Pennsylvania. The series is of moderately low extent. About 4,000 acres mapped in Prince William County, Virginia.
USDA, geographic setting: Jackland soils are on the Northern part of the Piedmont Plateau uplands commonly associated with the Triassic Region. These soils are on broad convex ridges and slope gradients range from 0 to 15 percent. They have developed in residuum that weathered from diabase, basalt and gabbro. Mean annual precipitation ranges from 36 to 44 inches and mean annual temperature ranges from 52 to 57 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Cecil: Strong lead
- Albano: Strong lead
- Montalto: Strong lead
- Worsham: Strong lead
- Aden: Strong lead
- Banister: Strong lead
- Benevola: Strong lead
See it on the map
Open a Jackland spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Jackland silt loam, 2 to 7 percent slopes, map unit 30B in Prince William County, Virginia.
- Official Series Description: Jackland(revised 01/2006), established.
- Taxonomic class: Fine, smectitic, mesic Aquic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.