Worsham soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 11 to 50 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Worsham soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Worsham spot on the map
Rated from the USDA soil survey record for Worsham loam (Stafford and King George Counties, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 38% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (24): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 39 in (99 cm)).
- Note Typically starts within about 11 in (28 cm) of the surface.
- Note Few rock fragments (about 3% by volume).
Layer by layer
- Sandy layerH1 A loam layer about 0 to 11 in down: about 18% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Clay-rich layerH2best layer A clay loam layer about 11 to 50 in down: about 38% clay, high plasticity when wet, gray when moist. Strong lead
- Loamy layerH3 A fine sandy loam layer about 50 to 92 in down: about 18% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The clay-rich layer (H2), 11 to 50 in down in the typical profile: gray (10YR 5/1); firm, moderately sticky, very plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from granite and gneiss.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Georgia, Virginia, in these survey areas: Cherokee, Gilmer, and Pickens Counties, Georgia; Fauquier County, Virginia; Prince William County, Virginia; Stafford and King George Counties, Virginia.
By state: wild clay in Georgia,wild clay in Virginia.
USDA, distribution and extent: Distribution: Virginia, North Carolina, South Carolina, Georgia, and Alabama
USDA, geographic setting: Landscape: Piedmont uplands
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Cecil: Strong lead
- Albano: Strong lead
- Caroline: Strong lead
- Jackland: Strong lead
- Lignum: Strong lead
- Susquehanna: Strong lead
- Aden: Strong lead
See it on the map
Open a Worsham spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Worsham loam, map unit Wr in Stafford and King George Counties, Virginia.
- Official Series Description: Worsham(revised 09/2025), established.
- Taxonomic class: Fine, mixed, active, thermic Typic Endoaquults
- Rated with rule version 2026-09-28.1; the method is on the About page.