Susquehanna soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 8 to 72 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Susquehanna soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Susquehanna spot on the map
Rated from the USDA soil survey record for Susquehanna soils, 2 to 10 percent slopes (Stafford and King George Counties, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (39): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 64 in (163 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Loamy layerH1 A loam layer about 0 to 8 in down: about 20% clay, moderate plasticity when wet, dark gray when moist. Possible
- Clay-rich layerH2best layer A clay layer about 8 to 72 in down: about 48% clay, high plasticity when wet, mottled light gray when moist. Strong lead
What it looks like raw
The clay-rich layer (H2), 8 to 72 in down in the typical profile: mottled light gray (2.5Y 7/2), dark red (10R 3/6), and strong brown (7.5YR 5/8). Raw colour is not fired colour.
About the soil
- Parent material: loamy marine deposits.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Virginia, in these survey areas: Prince William County, Virginia; Stafford and King George Counties, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Southern Coastal Plain in the states of Alabama, Arkansas, Florida, Georgia, Louisiana, Mississippi, Texas, and Virginia. The series is of large extent.
USDA, geographic setting: These nearly level to steep soils are in erosional upalnds of the Southern Coastal Plain. Slopes range from 1 to 17 percent. These soils formed in marine or stream deposits of silty clay and clay. The climate is warm and humid. The mean annual temperature is 68 degrees F., and average annual precipitation is 61 inches near the type location.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Caroline: Strong lead
- Cecil: Strong lead
- Worsham: Strong lead
- Aden: Strong lead
- Albano: Strong lead
- Bladen: Strong lead
- Braddock: Strong lead
See it on the map
Open a Susquehanna spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Susquehanna soils, 2 to 10 percent slopes, map unit SuC in Stafford and King George Counties, Virginia.
- Official Series Description: Susquehanna(revised 11/2018), established.
- Taxonomic class: Fine, smectitic, thermic Vertic Paleudalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.