Lignum soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 12 to 39 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lignum soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Lignum silt loam, 2 to 7 percent slopes (Moore County, North Carolina) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (33.5): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 27 in (69 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Note Few rock fragments (about 14% by volume).
Layer by layer
- TopsoilA A silt loam layer about 0 to 2 in down: about 18% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerE A silt loam layer about 2 to 12 in down: about 18% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
- Clay subsoilBtbest layer A silty clay layer about 12 to 39 in down: about 45% clay, high plasticity when wet, yellowish brown when moist. Strong lead
- Loamy layerC A silt loam layer about 39 to 56 in down: about 25% clay, moderate plasticity when wet, mottled light gray when moist. Possible
- BedrockCr Weathered bedrock about 56 to 80 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt), 12 to 39 in down in the typical profile: yellowish brown (10YR 5/6); firm, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from metavolcanics and/or residuum weathered from argillite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
- Paralithic bedrock typically about 56 in (142 cm) down.
Where it is mapped
Seen on the map as the most common soil in 4 map units in North Carolina, Virginia, in these survey areas: Fauquier County, Virginia; Moore County, North Carolina; Stafford and King George Counties, Virginia.
By state: wild clay in North Carolina,wild clay in Virginia.
USDA, distribution and extent: North Carolina, South Carolina, and Virginia. The series is of moderate extent.
USDA, geographic setting: Lignum soils are in depressions and on undulating uplands, in interstream divides, and around the heads of drainageways. Slope gradients are commonly 2 to 6 percent with a range of 0 to 15 percent. They formed in residuum weathered from argillite or other fine grained metavolcanic rocks. The mean annual air temperature is about 57 degrees F., and mean annual precipitation ranges from 38 to 45 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Cecil: Strong lead
- Worsham: Strong lead
- Albano: Strong lead
- Bladen: Strong lead
- Caroline: Strong lead
- Clover: Strong lead
- Craven: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lignum silt loam, 2 to 7 percent slopes, map unit LgB in Moore County, North Carolina.
- Official Series Description: Lignum(revised 02/2010), established.
- Taxonomic class: Fine, mixed, semiactive, thermic Aquic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.