Craven soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 9 to 56 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Craven soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Craven loam, 2 to 6 percent slopes (Stafford and King George Counties, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (21): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 47 in (119 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- Sandy layerH1 A loam layer about 0 to 9 in down: about 17% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Clay-rich layerH2best layer A clay layer about 9 to 56 in down: about 48% clay, high plasticity when wet, brownish yellow when moist. Strong lead
- Clay-rich layerH3 A clay layer about 56 to 92 in down: about 40% clay, moderate plasticity when wet, brownish yellow when moist. Promising
What it looks like raw
The clay-rich layer (H2), 9 to 56 in down in the typical profile: brownish yellow (10YR 6/6); very firm, sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy marine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Virginia, in these survey areas: Stafford and King George Counties, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Distribution: North Carolina, South Carolina, Georgia, and Virginia
USDA, geographic setting: Landscape: Coastal Plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Bladen: Strong lead
- Caroline: Strong lead
- Cecil: Strong lead
- Cullen: Strong lead
- Dogue: Strong lead
- Elbert: Strong lead
- Lignum: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Craven loam, 2 to 6 percent slopes, map unit CrB in Stafford and King George Counties, Virginia.
- Official Series Description: Craven(revised 02/2026), established.
- Taxonomic class: Fine, mixed, subactive, thermic Aquic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.