Talleyville soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 44 to 51 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Talleyville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Talleyville spot on the map
Rated from the USDA soil survey record for Talleyville silt loam, 3 to 8 percent slopes (New Castle County, Delaware) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 37% clay in the fine-earth portion.
- Note USDA labels this a "2Bt3" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (22): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky.
- Note Moderate thickness (about 7 in (18 cm)).
- Note Typically starts about 44 in (112 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 1% by volume).
Layer by layer
- TopsoilAp, E A silt loam layer about 0 to 10 in down: about 17% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Clay subsoilBt1, Bt2 A silt loam layer about 10 to 44 in down: about 26% clay, moderate plasticity when wet, strong brown when moist. Possible
- Clay subsoil2Bt3best layer A silty clay loam layer about 44 to 51 in down: about 37% clay, high plasticity when wet, red when moist. Strong lead
- Clay subsoil2Bt4 A clay layer about 51 to 64 in down: about 42% clay, high plasticity when wet, red when moist. Promising
- Clay-rich layer2BC A sandy clay layer about 64 to 72 in down: about 38% clay, high plasticity when wet, red when moist. Promising
What it looks like raw
The clay subsoil (2Bt3), 44 to 51 in down in the typical profile: red (2.5YR 4/6), percent strong brown (7.5YR 5/6); firm, slightly sticky. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
- Lithic bedrock typically about 98 in (250 cm) down.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Delaware, Pennsylvania, in these survey areas: Delaware County, Pennsylvania; New Castle County, Delaware.
By state: wild clay in Delaware,wild clay in Pennsylvania.
USDA, distribution and extent: Northern Delaware and probably adjacent areas in Pennsylvania and Maryland and possibly in Virginia. The series is of moderate extet - 5,000 to 10,000 acres.
USDA, geographic setting: The Talleyville soils developed in a silty mantle and the underlying residuum from basic igneous rocks, usually gabbro or diabase. They are nearly level to sloping soils in the uplands of the northern Piedmnont Plateau. Slopes are smooth and range from 0 to 10 percent, but most are between 2 and 5 percent. Mean annual temper- ature is about 50 degrees F, and mean annual precipitation is about 40 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Montalto: Strong lead
- Watchung: Strong lead
- Baile: Promising
- Glenelg: Promising
- Hatboro: Promising
- Broadkill: Promising
- Califon: Promising
- Chester: Promising
See it on the map
Open a Talleyville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Talleyville silt loam, 3 to 8 percent slopes, map unit TaB in New Castle County, Delaware.
- Official Series Description: Talleyville(revised 12/2006), inactive.
- Taxonomic class: Fine-silty, mixed, semiactive, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.