Califon soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 16 to 23 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Califon soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Califon spot on the map
Rated from the USDA soil survey record for Califon loam, 0 to 8 percent slopes, extremely stony (Chester County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (8.5).
- Note Moderate thickness (about 7 in (17 cm)).
- Note Typically starts within about 16 in (41 cm) of the surface.
- Note Few rock fragments (about 14% by volume).
Layer by layer
- TopsoilAp A loam layer about 0 to 10 in down: about 15% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerBA A loam layer about 10 to 16 in down: about 24% clay, moderate plasticity when wet, strong brown when moist. Possible
- Clay subsoilBtbest layer A clay loam layer about 16 to 23 in down: about 28% clay, moderate plasticity when wet, strong brown when moist. Promising
- Loamy layerBx A loam layer about 23 to 50 in down: about 24% clay, moderate plasticity when wet, variegated with equal parts of yellowish red when moist. Possible
- Loamy layerC A sandy loam layer about 50 to 60 in down: about 18% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 16 to 23 in down in the typical profile: strong brown (7.5YR 5/6); clay loam; firm. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from granite and gneiss.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
- Lithic bedrock typically about 80 in (203 cm) down.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Pennsylvania, in these survey areas: Chester County, Pennsylvania; Delaware County, Pennsylvania; Montgomery County, Pennsylvania; Northampton County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: MLRA 148. In North-central New Jersey and southeastern Pennsylvania. These soils are moderate in extent (24,000 acres)
USDA, geographic setting: Califon soils formed either in deeply weathered old till or colluvium derived predominantly from granitic gneiss. Slope gradients range from 0 to 15 percent. Climate is humid temperate. Average annual air temperature is 45 to 55 degrees F. and average annual precipitation is 40 to 45 inches. Frost free days range from 130 to 170 days and elevations range from 200 to 1100 feet above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Montalto: Strong lead
- Talleyville: Strong lead
- Chester: Promising
- Duffield: Promising
- Glenelg: Promising
- Hatboro: Promising
- Holly: Promising
See it on the map
Open a Califon spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Califon loam, 0 to 8 percent slopes, extremely stony, map unit CbB in Chester County, Pennsylvania.
- Official Series Description: Califon(revised 10/2007), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Typic Fragiudults
- Rated with rule version 2026-09-28.1; the method is on the About page.