Baile soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 8 to 45 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Baile soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Baile loam, 0 to 4 percent slopes (Prince William County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (14).
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 37 in (94 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- Loamy layerH1 A loam layer about 0 to 8 in down: about 21% clay, moderate plasticity when wet, dark gray when moist. Possible
- Loamy layerH2best layer A clay loam layer about 8 to 45 in down: about 28% clay, moderate plasticity when wet, bluish gray when moist. Promising
- Sandy layerH3 A sandy loam layer about 45 to 62 in down: about 18% clay, moderate plasticity when wet, bluish gray when moist. Weak indication
What it looks like raw
The loamy layer (H2), 8 to 45 in down in the typical profile: bluish gray (5B 6/1); friable, slightly sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium over residuum.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 15 map units in Delaware, Maryland, Pennsylvania, Virginia, in these survey areas: Baltimore County, Maryland; Cecil County, Maryland; Chester County, Pennsylvania; Delaware County, Pennsylvania; Harford County Area, Maryland; Lancaster County, Pennsylvania; New Castle County, Delaware; Prince William County, Virginia.
By state: wild clay in Delaware,wild clay in Maryland,wild clay in Pennsylvania,wild clay in Virginia.
USDA, distribution and extent: Pennsylvania, Maryland, and Virginia. This series is of moderate extent.
USDA, geographic setting: Baile soils are on upland depressions and footslopes in the northern Piedmont Plateau. Slopes range from 0 to 8 percent. These soils developed in contrasting materials of silty local alluvium over residuum from acid crystalline rocks, chiefly mica schist and granitized schist and gneiss. The mean annual temperature ranges from 45 to 55 degrees F., and the mean annual precipitation is 40 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Montalto: Strong lead
- Christiana: Strong lead
- Jackland: Strong lead
- Talleyville: Strong lead
- Aden: Strong lead
- Albano: Strong lead
- Appling: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Baile loam, 0 to 4 percent slopes, map unit 6A in Prince William County, Virginia.
- Official Series Description: Baile(revised 02/2008), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Typic Endoaquults
- Rated with rule version 2026-09-28.1; the method is on the About page.