Broadkill soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 13 to 32 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Broadkill soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Broadkill spot on the map
Rated from the USDA soil survey record for Broadkill mucky silt loam, 0 to 1 percent slopes, very frequently flooded, tidal (New Castle County, Delaware) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (17).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 19 in (48 cm)).
- Note Typically starts within about 13 in (33 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- TopsoilAseg A mucky silt loam layer about 0 to 13 in down: about 17% clay, moderate plasticity when wet, dark gray when moist. Weak indication
- Loamy layerCseg1best layer A silty clay loam layer about 13 to 32 in down: about 30% clay, moderate plasticity when wet, dark gray when moist. Promising
- Loamy layerCseg2 A silt loam layer about 32 to 80 in down: about 18% clay, moderate plasticity when wet, dark olive gray when moist. Possible
What it looks like raw
The loamy layer (Cseg1), 13 to 32 in down in the typical profile: dark gray (5Y 4/1), and dark olive gray (5Y 3/2); silty clay loam; friable; slightly sticky, slightly plastic; very fluid. Raw colour is not fired colour.
About the soil
- Parent material: fine-silty estuarine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Delaware, in these survey areas: New Castle County, Delaware.
By state: wild clay in Delaware.
USDA, distribution and extent: General area--Tidal marshes along the landward side of barrier island lagoons and along tidally influenced rivers and bays in Delaware, Maryland, New Jersey.
USDA, geographic setting: Parent Material--Fine-silty estuarine deposits
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Montalto: Strong lead
- Talleyville: Strong lead
- Watchung: Strong lead
- Baile: Promising
- Delanco: Promising
- Elsinboro: Promising
- Glenelg: Promising
- Hatboro: Promising
See it on the map
Open a Broadkill spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Broadkill mucky silt loam, 0 to 1 percent slopes, very frequently flooded, tidal, map unit Brm in New Castle County, Delaware.
- Official Series Description: Broadkill(revised 07/2025), established.
- Taxonomic class: Fine-silty, mixed, active, nonacid, mesic Fluventic Sulfaquents
- Rated with rule version 2026-09-28.1; the method is on the About page.