Bowmansville soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 7 to 26 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bowmansville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Bowmansville spot on the map
Rated from the USDA soil survey record for Bowmansville-Knauers silt loams (Berks County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 29% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 19 in (48 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 7 in down: about 14% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Loamy layerBgbest layer A silty clay loam layer about 7 to 26 in down: about 29% clay, high plasticity when wet, pinkish gray when moist. Promising
- Sandy layerCg A fine sandy loam layer about 26 to 43 in down: about 18% clay, moderate plasticity when wet, pinkish gray when moist. Weak indication
- Sandy layer2Cg A stratified gravel to sand layer about 43 to 65 in down: about 5% clay, low plasticity when wet, pinkish gray when moist. Weak indication
What it looks like raw
The loamy layer (Bg), 7 to 26 in down in the typical profile: pinkish gray (7.5YR 6/2); firm, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: recent alluvial deposits weathered from sandstone and siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: somewhat poorly drained.
- Lithic bedrock typically about 85 in (217 cm) down.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Pennsylvania, Virginia, in these survey areas: Berks County, Pennsylvania; Bucks County, Pennsylvania; Chester County, Pennsylvania; Fauquier County, Virginia; Lancaster County, Pennsylvania; Lebanon County, Pennsylvania; Lehigh County, Pennsylvania; Montgomery County, Pennsylvania.
By state: wild clay in Pennsylvania,wild clay in Virginia.
USDA, distribution and extent: Southeastern Pennsylvania, central New Jersey, Maryland, and Virginia. The series is of moderate extent.
USDA, geographic setting: Bowmansville soils are on nearly level flood plains. They formed in alluvial deposits derived from upland soil materials weathered from red and brown shale and sandstone or from dolerite or basalt. Climate is humid and temperate. Mean annual precipitation ranges from 40 to 46 inches; mean annual temperature ranges from 47 to 59 degrees F.; and the growing season ranges from 135 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Hagerstown: Strong lead
- Albano: Strong lead
- Appling: Strong lead
- Cecil: Strong lead
- Clover: Strong lead
- Dulles: Strong lead
- Fletcherville: Strong lead
See it on the map
Open a Bowmansville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 41%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bowmansville-Knauers silt loams, map unit Bo in Berks County, Pennsylvania.
- Official Series Description: Bowmansville(revised 02/2008), established.
- Taxonomic class: Fine-loamy, mixed, active, nonacid, mesic Fluventic Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.