Shelmadine soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 5 to 22 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Shelmadine soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Shelmadine spot on the map
Rated from the USDA soil survey record for Shelmadine silt loam, 3 to 15 percent slopes (Warren and Forest Counties, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note USDA labels this a "Btg" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (9).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 17 in (43 cm)).
- Note Typically starts within about 5 in (13 cm) of the surface.
- Note Few rock fragments (about 14% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 5 in down: about 14% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBtgbest layer A silty clay loam layer about 5 to 22 in down: about 28% clay, moderate plasticity when wet, light brownish gray when moist. Promising
- Clay subsoilBtx A silt loam layer about 22 to 42 in down: about 27% clay, moderate plasticity when wet, dark yellowish brown when moist. Possible
- Loamy layerC A channery loam layer about 42 to 60 in down: about 19% clay, low plasticity when wet, brown when moist. Weak indication
What it looks like raw
The clay subsoil (Btg), 5 to 22 in down in the typical profile: light brownish gray (10YR 6/2); silty clay loam; firm, moderately sticky, moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: till.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Pennsylvania, in these survey areas: Carbon County, Pennsylvania; Schuylkill County, Pennsylvania; Warren and Forest Counties, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Glaciated portions of Northern Appalachian Ridges in Eastern Pennsylvania and fringes of Glaciated Allegheny Plateau in western Pennsylvania. MLRA's 127, 139, 140, and 147. The series is of moderate extent, around 60,000 acres.
USDA, geographic setting: Nearly level to moderately sloping soils on upland flats, depressions, drainageways and stream heads. Slopes range from 0 to 15 percent. The soil formed in pre-Wisconsin age glacial or periglacial material derived from shale, siltstone, and sandstone. The climate is humid temperate; mean annual precipitation ranges from 860 to 1220 millimeters, mean annual air temperature ranges from 7 to 11 degrees C, and the frost-free season from ranges 130 to 170 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Armagh: Strong lead
- Cavode: Strong lead
- Brinkerton: Promising
- Comly: Promising
- Ernest: Promising
- Holly: Promising
- Kedron: Promising
- Wharton: Promising
See it on the map
Open a Shelmadine spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Shelmadine silt loam, 3 to 15 percent slopes, map unit ShC in Warren and Forest Counties, Pennsylvania.
- Official Series Description: Shelmadine(revised 05/2025), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Typic Fragiaquults
- Rated with rule version 2026-09-28.1; the method is on the About page.