Basher soil
Wild-clay potential
Weak indication
Weak indication: no layer of Basher shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Basher soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Basher silt loam (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 12% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 37 in (94 cm)).
- Note Typically starts about 35 in (89 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- TopsoilA A silt loam layer about 0 to 8 in down: about 12% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerBw1 A silt loam layer about 8 to 13 in down: about 12% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerBw2 A silt loam layer about 13 to 23 in down: about 12% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerC1 A silt loam layer about 23 to 35 in down: about 12% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerC2best layer A loam layer about 35 to 72 in down: about 12% clay, low plasticity when wet, gray when moist. Weak indication
What it looks like raw
The sandy layer (C2), 35 to 72 in down in the typical profile: gray (10YR 5/1); loam; friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy alluvium derived from acid, reddish sandstone, siltsone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in New York, Pennsylvania, in these survey areas: Delaware County, New York; Huntingdon County, Pennsylvania; Schoharie County, New York; Schuylkill County, Pennsylvania.
By state: wild clay in New York,wild clay in Pennsylvania.
USDA, distribution and extent: Southern New York, Pennsylvania, West Virginia, and possibly, New Jersey. MLRA 127, 140, and 147. The series is moderately extensive.
USDA, geographic setting: Basher soils are on flood plains and low terraces. Slope ranges from 0 to 3 percent. The soils formed in alluvium derived mainly from acid, reddish sandstone, siltstone and shale in both glaciated and residual areas. Mean annual temperature ranges from 45 degrees to 50 degrees F.; mean annual precipitation ranges from 32 to 45 inches; and mean frost-free season ranges from 120 to 180 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Edom: Strong lead
- Hublersburg: Strong lead
- Lakemont: Strong lead
- Opequon: Strong lead
- Phelps: Strong lead
- Purdy: Strong lead
- Brinkerton: Promising
- Ernest: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Basher silt loam, map unit Bs in Delaware County, New York.
- Official Series Description: Basher(revised 06/1999), established.
- Taxonomic class: Coarse-loamy, mixed, active, mesic Fluvaquentic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.