Norchip soil
Wild-clay potential
Weak indication
Weak indication: no layer of Norchip shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Norchip soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Norchip spot on the map
Rated from the USDA soil survey record for Norchip silt loam, 0 to 3 percent slopes (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 22% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts within about 15 in (38 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 25% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilA A silt loam layer about 0 to 7 in down: about 23% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Loamy layerEg A channery silt loam layer about 7 to 15 in down: about 20% clay, moderate plasticity when wet, percent grayish brown when moist. Weak indication
- Loamy layerBxbest layer A channery silt loam layer about 15 to 45 in down: about 22% clay, moderate plasticity when wet, percent light olive brown when moist. Weak indication
- Loamy layerC A channery silt loam layer about 45 to 72 in down: about 20% clay, moderate plasticity when wet, percent dark yellowish brown when moist. Weak indication
What it looks like raw
The loamy layer (Bx), 15 to 45 in down in the typical profile: percent light olive brown (2.5Y 5/4); very firm; brittle. Raw colour is not fired colour.
About the soil
- Parent material: loamy till dominated by siltstone, sandstone, and shale fragments.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 3 map units in New York, in these survey areas: Delaware County, New York; Otsego County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Higher elevations of the Glaciated Allegheny Plateau and Catskill Mountains. MLRA 140. The series is of moderate extent.
USDA, geographic setting: Norchip soils occupy nearly level areas or depressions on glaciated uplands. Slope ranges from 0 to 8 percent. The parent material is usually a firm till derived mainly from sandstone, siltstone, and some shale. Surficial deposits of alluvium or colluvium up to 51 cm (20 in) thick are present in some pedons. Mean annual air temperature ranges from 4 to 9 degrees C (39 to 48 degrees F). Mean annual precipitation ranges from 825 to 1790 mm (32 to 70 in) and the frost free days range from 110 to 155 days. Elevation ranges from 425 to 1100 m (1394 to 3608 ft) above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alden: Possible
- Canandaigua: Possible
- Bath: Weak indication
- Chenango: Weak indication
- Lewbath: Weak indication
- Lordstown: Weak indication
- Mardin: Weak indication
- Mongaup: Weak indication
See it on the map
Open a Norchip spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Norchip silt loam, 0 to 3 percent slopes, map unit No in Delaware County, New York.
- Official Series Description: Norchip(revised 05/2015), established.
- Taxonomic class: Fine-loamy, mixed, active, frigid Aeric Fragiaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.